IBM 8837 User Guide - Page 15
Features, specifications - btu
UPC - 000435421401
View all IBM 8837 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Features and specifications The following information is a summary of the features and specifications of the server. Depending on the server model, some features might not be available, or some specifications might not apply. Table 1. Features and specifications Microprocessor: v Intel™ Xeon® 2.8 GHz or higher depending on server model v Support for up to two microprocessors with Intel Hyper-Threading Technology and EM64T (extended memory 64 bit technology) v 800 MHz front-side bus (FSB) Memory: v Minimum: 512 MB v Maximum: 16 GB v Type: 2-way interleaved PC3200, 400 MHz, ECC DDR II SDRAM, registered DIMMs only v Sizes: 256 MB, 512 MB, 1 GB, 2 GB (when available) Expansion bays: Comes in 3 configurations: v Configuration 1 and 2 - Two 3.5-inch hot-swap SCSI or two 3.5-inch non-hot-swap (simple swap) SATA hard disk drives - One 9.5-mm high DVD-ROM drive (optional) v Configuration 3 - Four 2.5-inch hot-swap SCSI hard disk drives Expansion slots: v One PCI-X 133 MHz or PCI Ex8, full-length, full height (Note: PCI-E x8 (PCI-E) requires an optional riser card) v One PCI-X 100 MHz, half length, low-profile Power supply: v 585 watt hot-swap power supply standard v Optional redundant 585 watt power supply Size: v Height: 43 mm (1.69 in.) v Depth: 686 mm (27.0 in.) v Width: 440 mm (17.32 in.) v Weight: approximately 15.6 kg (34.5 lb) when fully configured or 12.7 kg (28 lb) minimum Integrated functions: v Baseboard management controller (BMC) v One LSI Ultra320 SCSI controller with RAID levels 1 and 1E capability v Two Broadcom 10/100/1000 Ethernet controllers with Wake on LAN® feature and Alert Standard Format support v Three Universal Serial Bus (USB) ports v One serial port v Keyboard port v Mouse port v Video port Acoustical noise emissions: v Sound power, idling: 6.9 bel maximum v Sound power, operating: 6.9 bel maximum Environment: v Air temperature: - Server on: 10° to 35°C (50.0° to 95.0°F); altitude: 0 to 2133 m (6998.0 ft) - Server off: 10° to 43°C (50.0° to 109.4°F); maximum altitude: 2133 m (6998.0 ft) v Humidity: - Server on: 8% to 80% - Server off: 8% to 80% Heat output: Approximate heat output in British thermal units (Btu) per hour: v Minimum configuration: 587 Btu/hr (172 watts) v Maximum configuration: 1878 Btu/hr (550 watts) Electrical input: v Sine-wave input (50-60 Hz) required v Input voltage low range: - Minimum: 100 V ac - Maximum: 127 V ac v Input voltage high range: - Minimum: 200 V ac - Maximum: 240 V ac v Input kilovolt-amperes (kVA), approximately: - Minimum: .172 kVA - Maximum: .550 kVA Notes: 1. Power consumption and heat output vary depending on the number and type of optional features installed and the power-management optional features in use. 2. These levels were measured in controlled acoustical environments according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a given location might exceed the average values stated because of room reflections and other nearby noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computers will operate. Chapter 1. Introducing the xSeries 336 Type 8837 server 3