IC Realtime AVS-5MD5110-VIR-DP Product Manual

IC Realtime AVS-5MD5110-VIR-DP Manual

Get IC Realtime AVS-5MD5110-VIR-DP PDF manuals and user guides View all IC Realtime AVS-5MD5110-VIR-DP manuals
Add to My Manuals
Save this manual to your list of manuals

IC Realtime AVS-5MD5110-VIR-DP manual content summary:

  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 1
    HDAVS Dome Camera User's Manual V1.0.2
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 2
    the camera. Safety Instructions The following categorized signal words with defined meaning might appear in the Manual. Signal Words performance, or unpredictable result. Provides methods to help you solve a problem or save you time. Provides additional information as the emphasis and
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 3
    reader software if the Guide (in PDF format) cannot be opened.  All trademarks, registered trademarks and the company names in the Manual are the properties of their respective owners.  Please visit our website, contact the supplier or customer service if there is any problem occurred when using
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 4
    Important Safeguards and Warnings Electrical Safety  All installation and operation should conform to your local electrical safety codes.  The power source shall conform to the requirement of the Safety Extra Low Voltage (SELV) standard, and supply power with rated voltage which conforms to
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 5
    device is installed and maintained by professional engineers.  The surface of the image sensor should not be exposed to laser beam radiation in an environment where a laser beam device is used.  Do not provide two or more power supply sources for the device; otherwise it might damage the device. 
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 6
    of the FCC Rules. This equipment generate, uses and can radiate radio frequency energy and, if not installed and used in accordance with the guide, may cause harmful interference to radio communication.  For class A device, these limits are designed to provide reasonable protection against harmful
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 7
    Table of Contents Foreword ...I 1 Introduction...1 1.1 General...1 1.2 Features ...1 2 Design...2 2.1 Dimension ...2 2.2 Cable ...3 3 Installation...6 4 Configuration ...9 4.1 Opening Main Menu...9 4.2 Setting Audio Input ...10 4.3 Operating OSD Menu ...12 5 Maintenance...14 Table of Contents IV
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 8
    the high definition monitoring needs for locations like financial center, telecom site, supermarket, hotel, government, school and factory. 1.2 Features  720p series support over 800 meter real-time transmission of video and control signal from RG59 cable; for 1080p to 4k series, the distance is
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 9
    2.1 Dimension 2 Design Figure 2-1 Model A (mm) Figure 2-2 Model B (mm) Figure 2-3 Model C (mm) Design 2
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 10
    method of ⑥(DIP switch), see Table 2-2. No. Port Name ① DC 12V Function Inputs DC 12V power. Please be sure to supply power as instructed in the Power Input Manual. Device abnormity or damage could occur if power is not supplied correctly. ② DC 12V or AC Inputs DC 12V or AC 24V power
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 11
    ③ Video Output Connects to HDAVR to output video signal. ④ Audio Input Connects to sound-pick-up devices to receive audio signal. ⑤ Power Output Supplies DC12V 2W power. ⑥ DIP Switch Dial switches to change output mode. Switch up indicates "ON", switch down indicates "OFF." Table 2-1 Design 4
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 12
    Switch1 OFF ON ON OFF Switch2 OFF ON OFF ON Table 2-2 Output Mode AVS CVBS AHD TVI Cable type might vary with different cameras, and the actual product shall prevail. Design 5
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 13
    3 Installation  Make sure the mounting surface is strong enough to hold at least three times of the camera weight.  Keep the protection film on the dome before installation and adjustment finished to avoid possible scratch.  Properly handle the device after unpacking. Do not expose the device in
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 14
    Figure 3-2 No. Item No. Item No. Item No. Item ① Mounting surface ② Expansion bolt ③ Pedestal ④ Self-tapping screw ⑤ Locking screw ⑥ Dome ⑦ Wrench ⑧ Screw Cover Table 3-2 Step 1 Find the mounting template sticker from the accessory pack and stick it to the mounting surface①. Step 2
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 15
    Figure 3-3 Figure 3-4 Step 7 Put the Dome⑥ back on and fasten the locking screws⑤. For the models with vari-focal lens, you can adjust the zoom and focus through HDAVR device. Installation 8
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 16
    4 Configuration Power up the camera and connect it to HDAVR device with coaxial cable, then the live view screen is displayed. The following instructions will guide you to configure your camera. The number of the coaxial port on HDAVR will display at the lower left corner of the live view window
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 17
    Figure 4-2 Right-click anywhere on the screen to return to the previous menu until you goes back to the live view screen interface. 4.2 Setting Audio Input Audio signal acquisition is available on select models. Step 1 In the Main Menu interface (Figure 4-2), select CAMERA > ENCODE > Encode. The
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 18
    Figure 4-3 Step 2 In the Channel list, select the camera that you want to configure according to the coaxial port number. Step 3 In the Main Stream column, click More Setting. The More Setting interface is displayed. See Figure 4-4. Figure 4-4 Step 4 In the More Setting interface, you can configure
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 19
    4.3 Operating OSD Menu Step 1 In the live view screen interface, right-click within the live view window of the camera that you want to configure. The shortcut menu (Figure 4-1) is displayed. Step 2 Click PTZ. The PTZ setting interface is displayed. See Figure 4-5. Step 3 Click Figure 4-5 to see
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 20
    Table 4-1 If there is " " as the value of an OSD item, click Enter to go to the next level of this item. Click Return to go back to the previous level. Clicking Cancel is to exit OSD menu without saving the modifications.  Interfaces of different HDAVR might vary, and the actual product shall
  • IC Realtime AVS-5MD5110-VIR-DP | Product Manual - Page 21
    Desiccant Replacement  Carefully follow the instructions in the manual when performing any disassembly operation about the device; otherwise, it might cause water leakage or poor image quality due to unprofessional disassemble.  Please contact after-sale service for desiccant replacement if there
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
HDAVS Dome Camera
User’s Manual
V1.0.2