Icom IC-7100 Advanced Instructions - Page 146
Using the DR mode scan, Example
View all Icom IC-7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
Previous view 8 D-STAR OPERATION "FROM" (Access repeater) setting (Continued) DDUsing the DR mode scan The DR mode scan is useful to find a repeater. To quickly find a repeater, the DR mode scan skips repeaters that are not specified as an access repeater. (The "USE (FROM)" setting is set to "NO" (SKIP is set) on the repeater list.) Example: S elect the "Hirano" repeater using the DR mode scan. qqPush DR (C) to select the DR mode. wwPush MENU (C) to display the "D-1" screen (D-1 menu). eeTouch [SCAN](D) to start the DR mode scan. • The frequency decimal point and "FROM" blink while scanning. • The repeaters in the repeater list are sequentially displayed. • The scan pauses when a signal is received. The scan resumes the same as other scans. (p. 12-5) rrWhen the transceiver receives a signal from a repeater, the scan stops, then touch [SCAN](D). • The DR mode scan is cancelled. You can skip certain repeaters as a scan target. You can also skip all repeaters in certain groups from a scan. See page 9-42 for details. NOTE: Even if the transceiver receives a signal from a repeater, the repeater may not receive the transceiver's signal, because the repeater's output power is higher than the transceiver's. The DR mode scan also scans simplex frequencies if they are entered in the repeater list. Left Display Center Right The L, R, C or D in the instructions indicate the part of the controller. L: Left side R: Right side C: Center bottom D: Display (Touch screen) Blinks Touch [SCAN] The repeaters are sequentially displayed. While DR mode scanning Means "JM1ZLK" is using the "Hirano" repeater. While receiving a signal from a repeater Touch [SCAN] Blinks While receiving a signal on 438.030. "Hirano" repeater is selected in "FROM." 8-10