Icom IC-7100 Advanced Instructions - Page 26
Sm-50 (option), Ptt Lock Switch, Low Cut Switch, Ptt Lock Indicator [lock], Mic Gain Volume [mic Gain]
View all Icom IC-7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Previous view 1 PANEL DESCRIPTION Microphone (Continued) The optional OPC-589 cable is required to connect these 8-pin microphones. DDSM-50 (Option) q PTT SWITCH Hold down to transmit, release to receive. w P TT LOCK SWITCH Push to lock the PTT switch in the transmit mode. r e q w y DDSM-30 (Option) TOP VIEW e UP/DOWN SWITCHES [UP]/[DN] Change the selected readout frequency or memory channel. • Holding down continuously changes the frequency or memory channel number. • While holding down XFC , the transmit readout frequen- cy can be controlled while in the split frequency mode. • The [UP]/[DN] switch can simulate a key paddle. Preset in the "KEYER SET" mode (U/D KEY; MIC Up/Down Keyer). (p. 4-10) r L OW CUT SWITCH Push (SM-50)/Slide (SM-30) to cut out the low fre- quency components of input voice signals. t P TT LOCK INDICATOR [LOCK] (Only for the SM-30) Lights red when the PTT lock switch (w) is ON. q w t BOTTOM VIEW y M IC GAIN VOLUME [MIC GAIN] Rotate to adjust the microphone output level. • Use this control as an addition to the microphone gain setting of the connected transceiver. Rotating the control too far clockwise may result in an output level that is too high and transmit signal distortion. yr OFF ON MIC GAIN LOW CUT 1-22