Icom IC-7100 Advanced Instructions - Page 287

Previous view 14 VOICE MEMORY FUNCTION Start to record when the [PTT] switch is pushed The transceiver starts to record the transmitted audio when the [PTT] switch is pushed. After transmitting, when the transceiver receives a signal in a given amount of time, it also records the received audio. Therefore, you can record all communication audio using this function. qqPush SET(C) to enter the Set mode. wwTouch the "PTT Auto REC" item of the "Voice Memo" Set mode. (V oice Memo > QSO Recorder > Recorder Set > PTT Auto REC) • If the specified item is not displayed, touch [∫] or [√](D) one or more times to select the page. eeTouch "ON." • OFF : T he transceiver does not start to record when the [PTT] switch is pushed. • O N : T he transceiver starts to record when the [PTT] switch is pushed. rrPush SET(C) to exit the Set mode. Left Display Center Right The L, R, C or D in the instructions indicate the part of the controller. L: Left side R: Right side C: Center bottom D: Display (Touch screen) SET NOTE: When you set PTT AUTO REC to ON, see the notes below. • T he transceiver also starts to record audio when the optional microphone's [PTT] switch is pushed, transmitting using the VOX function or the CI-V remote controller. • All transmit audio is recorded. (W hen "RX Only" is set in the "REC Mode" item, transmit audio is not recorded) • W hen the transceiver receives a signal less than 10 seconds after transmitting, the transceiver also records the receive audio. • In addition, when the transceiver receives a signal, and then receives other signals less than 10 seconds later, it records all signals audio. Touch "Voice Memo." Touch "QSO Recorder." Touch "Recorder Set." 14-11 Touch "PTT Auto REC." Touch "ON."