Icom IC-7100 Advanced Instructions - Page 325

Previous view 17 SET MODE Function Set mode Monitor (Default: OFF) Function > Monitor (Monitor) Turn the monitor function ON or OFF. This function allows you to monitor your transmit signal in any mode other than CW. • OFF: Turns the function OFF. • ON: Monitors your transmit signal. Monitor Level (Default: 50%) Function > Monitor Level (Monitor Level) Adjust a transmit signal monitor level number between 0% (no audio), 1% (minimum) and 100% (maximum) for the voice synthesizer. Beep Level (Default: 50%) Function > Beep Level (Beep Level) Adjust the confirmation and band edge beep tones output level to between 0% (no beep), 1% (minimum) and 100% (maximum). Beep Level Limit (Default: ON) Function > Beep Level Limit (Beep Level Limit) Turn the confirmation and band edge beep tones output level limiting ON or OFF. When you set this item to ON, the beep tones are adjusted by the [AF] control until rotating the control reaches to the specified level. Further rotation will not increase the volume of the beep tones. • OFF: Beep level adjustment is not limited. • ON: Beep level adjustment is limited with the [AF] control. Beep (Confirmation) (Default: ON) Function > Beep (Confirmation) (Beep (Confirmation)) Turn the confirmation beep ON or OFF. Set the beep output level in the "Beep Level" item as described above. • OFF: The confirmation beep is OFF. (Silent opera- tion) • ON: The confirmation beep sounds each time a switch is pushed. Band Edge Beep (Default: ON (Default)) Function > Band Edge Beep (Band Edge Beep) When you tune into or out of an amateur band's fre- quency range, you can hear a beep tone. If you select "ON (User)" or "ON (User) & TX Limit," you can program a total of 30 band edge frequencies in the "User band Edge" item. You can set the beep output level in the "Beep Level" item as described to the left. • OFF: Band edge beep is OFF • ON (Default): When you tune into or out of the de- fault amateur band's frequency range, a beep sounds. • ON (User): When you tune into or out of a user pro- grammed amateur band's frequency range, a beep sounds. • ON (User) & TX Limit: When you tune into or out of a user pro- grammed amateur band's frequency range, a beep sounds. In addition, transmission is inhibited outside the programmed range. User Band Edge Function > User Band Edge (User Band Edge) This "User Band Edge" item appears only when "ON (User)" or "ON (User) & TX Limit" is selected in the "Band Edge Beep" item. When you select "ON (User)" or "ON (User) & TX Limit" in the "Band Edge Beep" item, you can program a total of 30 band edge frequencies in this item. See page 3-14 for programming details. RF/SQL Control (Default: RF+SQL) Function > RF/SQL Control (RF/SQL Control) Set the [RF/SQL] control operation. • AUTO: [RF/SQL] functions as only an RF gain con- trol in SSB, CW and RTTY; a squelch control in AM, FM, WFM and DV. • SQL: [RF/SQL] functions as a squelch control. • RF+SQL: [RF/SQL] functions not only as an RF gain control, but also as a squelch control in all modes. 17-18