Icom IC-7100 Advanced Instructions - Page 329
MIC AF Out, Power OFF With No Controller, REF Adjust, Mode Select
View all Icom IC-7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 329 highlights
Previous view 17 SET MODE Function Set mode (Continued) MIC AF Out (Default: OFF) Function > MIC AF Out (MIC AF Out) Select the [MIC] connector output function. • OFF: The [MIC] connector does not output the re- ceived audio. When using the optional HM-151 remote control mic, select "OFF." • ON: The [MIC] connector outputs the received audio. When using a speaker microphone or headset, select "OFF." [F-1] (Default: SPLIT) Function > RC MIC > [F-1] ([F-1]) The function listed below can be assigned to [F-1] on the optional HM-151 remote control mic. • --(No function), P.AMP/ATT, AGC, NB, NR, NOTCH, RIT, AUTOTUNE/RX>CS, TS, MPAD, M-CLR, BANK, SPLIT, A/B, DUP, TONE/DSQL, COMP, TBW, METER, DR, FROM/TO (DR), SCAN, Voice TX (T1) [F-2] (Default: A/B) Function > RC MIC > [F-2] ([F-2]) The function listed below can be assigned to [F-2] on the optional HM-151 remote control mic. • --(No function), P.AMP/ATT, AGC, NB, NR, NOTCH, RIT, AUTOTUNE/RX>CS, TS, MPAD, M-CLR, BANK, SPLIT, A/B, DUP, TONE/DSQL, COMP, TBW, METER, DR, FROM/TO (DR), SCAN, Voice TX (T1) Mode Select (Default: All mode) Function > RC MIC > Mode Select (Mode Select) Disables the mode selection with the optional HM-151 remote control mic, to simplify operation. • SSB, CW, RTTY, AM, FM, WFM, DV Power OFF (With No Controller) (Default: ON) Function > Power OFF (With No Controller) (Power OFF (With No Controller)) Select to automatically turn OFF the transceiver when the controller is disconnected from the transceiver. • OFF: The transceiver power is ON. • ON: The transceiver is automatically turned OFF. REF Adjust Function > REF Adjust (REF Adjust) During frequency calibration, set the internal reference frequency to between 0% and 100% range. NOTE: The default setting is different for each transceiver. 17-22