Icom IC-7100 Advanced Instructions - Page 338
Others Set mode, Version, Clone Mode, Clone Master Mode, Touch Screen Calibration, Partial Reset
View all Icom IC-7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 338 highlights
Previous view 17 SET MODE Others Set mode Version Others > Information > Version (VERSION) Shows the transceiver firmware's version number. Clone Mode Others > Clone > Clone Mode Select to read or write the CS-7100 data from or to the PC, and/or to receive data from a Master transceiver. See page 19-5 for details. Clone Master Mode Others > Clone > Clone Master Mode Select to write your IC-7100 (Master) data to another IC-7100 (Sub). See page 19-5 for details. Touch Screen Calibration Others > Touch Screen Calibration Touch to adjust the touch screen. See page 19-10 for details. Partial Reset Others > Reset > Partial Reset A Partial reset resets operating settings to their default values (VFO frequency, VFO settings, menu contents) without clearing the items below: See page 19-3 for details. All Reset Others > Reset > All Reset Reset the CPU, if the internal CPU malfunctions due to static electricity, and so on. All reset clears all programming and returns all settings to their factory defaults (including the programmed data you purchased). Therefore, after the All resetting, you cannot use the transceiver in the DR mode until reprogramming the repeater list. See page 19-4 for details. ✓✓ Recommend! Before the All resetting, we recommend you save the programmed data you purchased onto an SD card. See page 13-6 for details. 17-31