Icom IC-7100 Advanced Instructions - Page 347
All reset, Reset, After performing the All reset, When you cannot enter the Set mode
View all Icom IC-7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 347 highlights
Previous view 19 MAINTENANCE Resetting the CPU (Continued) DDAll reset ✓✓ Recommended! After an All reset, you cannot use the transceiver in the DR mode because the repeater list will be cleared. So we recommend you save the programmed data onto an SD card, or to your PC using the optional cloning software (CS-7100) before doing an All reset. After the All reset is finished, load or write the saved data into your transceiver. qqPush SET(C) to enter the Set mode. wwTouch the "Reset" item of the "Others" Set mode. (Others > Reset) • If the specified item is not displayed, touch [∫] or [√](D) one or more times to select the page. eeTouch "All Reset." rrWhen the dialogue appears, touch "NEXT." Left Display Center Right The L, R, C or D in the instructions indicate the part of the controller. L: Left side R: Right side C: Center bottom D: Display (Touch screen) ttAfter reading the displayed message, touch "YES" to perform the All reset. yyThe transceiver displays "ALL RESET," then the All reset is completed. After performing the All reset All reset clears all programming and returns all settings to their factory defaults. Therefore, the repeater list, Memory channel contents, filter setting and so on will be cleared, so you will need to reprogram your operating settings. When you cannot enter the Set mode If a touch screen operation error or an unexpected operation occurs, you cannot enter the Set mode. In this case, perform the All reset as described below: ➥➥While holding down SET(C), SPEECH (R) and MPAD (R), push [PWR] (L). 19-4