Icom IC-7100 Advanced Instructions - Page 48
Selecting ‘kHz’ step, Selecting
View all Icom IC-7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Previous view 3 BASIC OPERATION Setting frequency (Continued) DDSelecting 'kHz' step When the 'kHz' Quick Tuning is selected, the frequency can be changed in the selected 'kHz' steps. The steps can be memorized, depending on the operating modes. qqOn the Mode selection screen, select the desired operating mode. (p. 3-17) wwTouch the kHz digits for 1 second to enter the Tuning step selection screen. • The 'kHz' Quick Tuning function is turned ON, and then the "Z" icon is displayed. eeTouch the desired tuning step to select the desired 'kHz' step. • 0.1, 1, 5, 6.25, 9, 10, 12.5, 20, 25, 50 and 100 kHz are selectable. • If the desired step is not displayed, touch [Y] or [Z](D) to select the page. • On the Tuning step selection screen, rotating the Dial also selects the tuning step. • If desired, touch [](D) or push MENU (C) to return to the normal operating screen. rrRepeat steps q to e to select the Quick tuning steps for other modes. Touch the kHz digits for 1 second • Tuning step selection screen Selects pages Cancel edit DDSelecting 1 Hz step You can change the frequency in 1 Hz steps for fine tuning. ➥➥Touch the Hz digits for 1 second to turn the 1 Hz tuning step ON or OFF. NOTE: • When the RIT function is used, it also tunes in 1 Hz tuning steps. • The frequency changes in 50 Hz steps when the [UP]/[DN] switches of the microphone are used for frequency tuning (if the quick tuning function is not selected.) Left Display Center Right The L, R, C or D in the instructions indicate the part of the controller. L: Left side R: Right side C: Center bottom D: Display (Touch screen) Touch the Hz digits for 1 second 1 Hz indication 3-9