Icom IC-7100 Advanced Instructions - Page 51
To select the Scan edge channel 1B, To transmit on 1.025 MHz lower frequency
View all Icom IC-7100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Previous view 3 BASIC OPERATION Setting frequency (Continued) DDDirect frequency input (Continued) • Split offset frequency input qqTouch the MHz digits to enter the Band selection dis- play. wwTouch [F-INP](D) to enter the Direct input screen. eeIf the Shift direction is minus, touch "• (-)." • [SPLIT] changes to [-SPLIT], and displays the Minus setting mode. rrTouch the desired number to enter the desired frequency shift. • -9.999 to +9.999 MHz can be set in 1 kHz steps. ttTouch [SPLIT] or [-SPLIT](D) to input the frequency shift to the transmit frequency, and the Split function is turned ON. [Example] To transmit on a 10 kHz higher frequency: ➥➥Touch [1], [0] then [SPLIT]. To transmit on 1.025 MHz lower frequency: ➥➥Touch 1], [0], [2], [5] then [-SPLIT]. • Memory channel selection qqOpen the Direct input screen. wwTouch the desired memory channel number. • Selectable memory channels are 1 to 99 in the selected memory bank A to E. The memory channels in the other memory banks cannot be selected. • Scan edge channels and Call channels can also be selected. (Shown in the table to the right below.) eeTouch [MEMO](D) to select the channel. • The selected memory channel is displayed, and then exit the Direct input screen. • If desired, touch "CE" to delete the entered digits. • If desired, touch [](D) or push MENU (C) to exit the Direct input screen. [Example] To select the Memory channel 24: ➥➥Touch [2], [4] then [ENT]. To select the Scan edge channel 1B: ➥➥Touch [1], [0], [1] then [ENT]. To select the CALL2 channel on the 430 MHz band: ➥➥Touch [1], [0], [9] then [ENT]. Touch the MHz digits Touch [F-INP] • Direct input screen Enter a "." decimal point, or minus (-) input for Split offset Shows the input digits Enter the Split offset Enter the Memory channel Enter the frequency Cancel edit Delete entering • Scan edge channels and Call channels Channel Input Channel Input Scan 1A 100 1B 101 edge 2A 102 2B 103 channels 3A 104 3B 105 Call 144 MHz CALL1 106 144 MHz CALL2 107 channels 430 MHz CALL1 108 430 MHz CALL2 109 The L, R, C or D in the instructions indicate the part of the controller. L: Left side, R: Right side, C: Center bottom D: Display (Touch screen) 3-12