Home » Image Fitness Manuals » Exercise and Fitness » Image Fitness Renew 815 Spa » Manual Viewer

Image Fitness Renew 815 Spa Canadian English Manual

Image Fitness Renew 815 Spa Manual

Get Image Fitness Renew 815 Spa PDF manuals and user guides

View all Image Fitness Renew 815 Spa manuals

Add to My Manuals
Save this manual to your list of manuals

Image Fitness Renew 815 Spa manual content summary:

Image Fitness Renew 815 Spa | Canadian English Manual - Page 1
you have questions, or if there are missing parts, we will guarantee complete satisfaction through direct instructions in this manual before using this equipment. Save this manual for reference. Patent Pending USER'S MANUAL Visit our website at www.imagefitness.com new products, prizes, fitness
Image Fitness Renew 815 Spa | Canadian English Manual - Page 2
Placement 2 Important Safety Instructions 3 Before You Begin 5 Choosing a Location for the Hydrotherapy Spa 6 Assembly 7 Using the Hydrotherapy Spa 10 Maintenance 13 Trouble-shooting 14 Limited 90-Day Spa Warranty 19 Ordering Replacement Parts Back Cover Note: A PART LIST and an EXPLODED
Image Fitness Renew 815 Spa | Canadian English Manual - Page 3
location you select for the spa will support this weight, plus the weight of the occupants. 6. Inspect and tighten all parts regularly. Replace any worn parts immediately. 7. DANGER-Risk of injury: Do not remove or alter the covers on the suction fittings. Never operate the spa if the suction guard
Image Fitness Renew 815 Spa | Canadian English Manual - Page 4
persons with pre-existing health problems, such as obesity, heart disease, high or low blood pressure, circulatory problems, or diabetes to consult time while using the spa, discontinue use and contact a physician. WARNING: Read all instructions before using the spa. ICON assumes no responsibility
Image Fitness Renew 815 Spa | Canadian English Manual - Page 5
it wherever there is an electrical outlet. The spa allows you to relax and unwind in the comfort of your own home. For your benefit, read this manual carefully before using the IMAGE® RENEW 815. If you have additional questions, please call our Customer Service Department toll-free at 1-888-936-4266
Image Fitness Renew 815 Spa | Canadian English Manual - Page 6
spa to permit servicing of the unit. The diameter of the tub is 69". You should allow for this size, plus the size of the spa jet unit plus room to remove the cover be able to support the weight of the spa when it is filled with water, plus the weight of the occupants. the spa weighs approximately 2,
Image Fitness Renew 815 Spa | Canadian English Manual - Page 7
beginning assembly, carefully read the following information and instructions: • Place all parts in a cleared area and remove the packing of the Inflatable Liner (29) to the fastener strip on the edge of the Spa Surround (9). Start the flap where the fastener strip starts and pull the flap tight as
Image Fitness Renew 815 Spa | Canadian English Manual - Page 8
connector on the dry side jet pack (A). Attach the left side in the same manner. Important: If the threaded collars are not fully tightened, the spa will not function. Position the Pillow (26) over the hole in the top of the wet side jet pack (B). Push the fasteners on the Pillow
Image Fitness Renew 815 Spa | Canadian English Manual - Page 9
there are no wrinkles. 29 Air Valve Air Valve 6. Before filling the spa with water, make sure that the spa is in the desired location, that it can easily be serviced, and that the cover can easily be removed. Once the spa is filled, it will have to be drained before it can be moved
Image Fitness Renew 815 Spa | Canadian English Manual - Page 10
pumping unit. Turn on the console (see USING THE CONSOLE on page 12). The pumping unit will heat the water as it pumps. Cover the spa with the spa cover. The spa cover must be tight. The temperature can be set or changed by the control on the console (see USING THE CONSOLE on page 12
Image Fitness Renew 815 Spa | Canadian English Manual - Page 11
Flat Wrench be removed for Filter Cap cleaning and replacement by Filter removing the cover cap and the filter cap and then pulling the filter from the spa jet unit. IMPOR- TANT: You must prime the spa jet unit (see the instructions on page 10) each time you have cleaned the filter. 11
Image Fitness Renew 815 Spa | Canadian English Manual - Page 12
Shell (15) to the dry side jet pack. • Locate the pump inside the spa jet unit. • The nut on one side of the pump must be unscrewed and the unit must be tipped on its side • Rock the spa jet unit slightly, until all the water has drained from the pump. • Replace the
Image Fitness Renew 815 Spa | Canadian English Manual - Page 13
alkaline pH level, between 7.2 and 7.8, in the spa. Severe problems can occur when the pH balance is not maintained parts in the spa jet unit. Also, the sanitation agents in the water will not be effective if the pH level is not properly maintained. Damage caused by improper pH levels is not covered
Image Fitness Renew 815 Spa | Canadian English Manual - Page 14
pump may have a bad bearing. Contact our customer service department. 6. SYMPTOM: THE WATER DOES NOT HEAT a. The heater is attached to the pump in the spa jet unit. If the pump is operating, the water should heat. Cover the spa with the spa cover. The spa cover must be tight. The water will heat at
Image Fitness Renew 815 Spa | Canadian English Manual - Page 15
. Add water until the filter and jets are covered. b. This problem is caused by excess air in the pump circulation system. Check to see if the primer cap is fully tightened. Prime the pump again and fully tighten the primer cap (see PRIMING THE SPA JET UNIT on page 10). c. Check that the
Image Fitness Renew 815 Spa | Canadian English Manual - Page 16
NOTES 16
Image Fitness Renew 815 Spa | Canadian English Manual - Page 17
NOTES 17
Image Fitness Renew 815 Spa | Canadian English Manual - Page 18
CUSTOMER RECORD Model No.: Retailer Name: Retailer Address: Serial No.: Purchase Date: 18
Image Fitness Renew 815 Spa | Canadian English Manual - Page 19
Limited 90 Day Spa Warranty ICON Health & Fitness, Inc. (ICON), warrants this product to be free from defects in workmanship and material, under normal use and service conditions, for a period of 90 days from the date of purchase. Specifically covered under this warranty are the spa shell, the
Image Fitness Renew 815 Spa | Canadian English Manual - Page 20
of the product (IMAGE® RENEW 815 spa) • The SERIAL NUMBER of the product (see the front cover of this manual) • The KEY NUMBER and DESCRIPTION of the part(s) (see the PART LIST/EXPLODED DRAWING attached to the center of this manual). IMAGE® is a registered trademark of ICON Health & Fitness, Inc
Image Fitness Renew 815 Spa | Canadian English Manual - Page 21
's manual for further important information. Heating the Spa The heating system in your spa is designed to be economical for long-term use. Combined with the fact that water absorbs heat very slowly, the effect is that it will Customer Service If you have any questions or if you encounter problems
Image Fitness Renew 815 Spa | Canadian English Manual - Page 22
Inflatable Cover #8 x 1/2" Screw Cover Panel Overlay Filter Cap Spa Surround Fixed Jet Spa Cover Heater Manuals (User's Manual et Livret d'Instructions) Foot Pump Video Note: "#" indicates a non-illustrated part. Specifications are subject to change without notice. See the back cover of this manual
Image Fitness Renew 815 Spa | Canadian English Manual - Page 23
11 4 29 9 45 23 44 22 41 31 39 25 34 8 26 16 42 6 52 42 42 5 28 48 5 1 15 5 5 49 35 43 43 36 52 5 36 48 37 49 20 36 32 13 36 54 7 12 33 24 14 21 10 27 10 27 18 38 17 42 19 18 38 50 2 40 42 53 51 50 53 51 3 46 47 30 R1199A EXPLODED DRAWING-Model No. 831.