Insignia NS-CZ14XWH7 Quick Setup Guide

QUICK SETUP GUIDE

WiFi Connected

Chest Freezer (12.2,

14.1, or 17.6 Cu.Ft.)

NS-CZ12XWH7/NS-CZ14XWH7/NS-CZ18XWH7

Before using your new product, please read these instructions to prevent any damage.

SETTING UP YOUR FREEZER

Before using your freezer

•

Remove the exterior and interior packing.

•

Let the freezer stand upright for approximately two hours

before connecting it to power.

•

Wipe the inside.

•

When moving your freezer, do not tilt it beyond 45° from

upright.

Finding a suitable location

•

This freezer is designed to be free standing only, and should

not be recessed or built-in.

•

Place your freezer on a floor that is strong enough to

support the freezer when it is fully loaded.

•

If your freezer is located too far from your WiFi router, the

signal may be too weak for a good connection. In such

cases a WiFi range extender will improve connectivity.

•

Allow 7.9 inches (20 cm) of space between the sides of the

freezer and the walls, 3.9 inches (10 cm) between the back

of the freezer and the wall, and 27.5 inches (70 cm) between

the top of the freezer and the ceiling.

•

If you locate the freezer next to a fixed wall, allow sufficient

space on the hinge side for the door to swing open.

•

Locate the freezer away from direct sunlight and sources of

heat, such as a stove, heater, or radiator. Direct sunlight may

affect the acrylic coating and heat sources may increase

electrical consumption. Extremely cold temperatures may

also prevent the freezer from performing properly.

•

Avoid locating the freezer in moist areas.

INTRODUCING THE

INSIGNIA CONNECT APP

Download the Insignia Connect app

to use additional features such as

open-door and temperature alerts.

App download is optional – your freezer

works normally without it!

FIND YOUR

USER GUIDE

ONLINE!

Go to www.insigniaproducts.com, then click

Support & Service

.

Enter

NS-CZ12XWH7

,

NS-CZ14XWH7

, or

NS-CZ18XWH7

in the box

under

Manual, Firmware, Drivers & Product Information

, then click

►

.

PACKAGE CONTENTS

• 12.2, 14.1, or 17.6 cubic foot chest freezer

• Storage basket

•

Quick Setup Guide

CONNECTING YOUR FREEZER TO WIFI

(OPTIONAL)

1

Make sure that your mobile device is connected to your

preferred WiFi network.

2

Download and open the free Insignia Connect Device

app from the App Store or Google Play. (Apple: iOS 9 or

later, Android: 6.0.1 Marshmallow or later)

3

Log in or sign up for a Best Buy or Insignia Connect

Device account.

4

On your freezer, press and hold the

-/+

and

Quick Freeze

buttons for two seconds to unlock the control panel.

5

Press and hold the

Quick Freeze

button for five seconds

until you see “0” on the control panel.

6

Press

-/+

once. “AP” is displayed.

7

In the app, tap

Set Up Device

, then follow the on-screen

directions to complete setup.

Notes:

• The Control panel will display the temperature after

10 seconds, but WiFi pairing mode will remain active.

• You may need to repeat steps 4-6 to put the freezer back

into AP mode if the app cannot find your freezer.

• Your freezer uses the 2.4GHz WiFi spectrum. If your router

provides both 2.4GHz and 5GHz, select the 2.4GHz band.

USING YOUR FREEZER

1

Plug in your freezer. Wait for 30 minutes, then open the

freezer door to determine if the freezer is working properly.

2

Press the

-/+

and

Quick Freeze

buttons at the same time

for three seconds to unlock the control panel.

3

Press

+

or

-

to set the temperature inside the freezer. The

temperature loops back to the warmest setting when the

coldest temperature is reached.

Using the Lock button

•

To prevent accidental activation, the control panel

automatically locks after 30 seconds. To use the control

panel, press and hold the

-/+

and

Quick Freeze

buttons at

the same time for three seconds.

Quick Freezing foods

The quick freeze mode lowers the temperature below the

normal operating temperature to quickly freeze foods.

1

Press and hold the

-/+

and

Quick Freeze

buttons at the

same time for two seconds to unlock the control panel.

2

Press the

Quick Freeze

button to enter quick freeze mode.

The blue snowflake turns on.

The quick freeze mode turns off after three hours.

Switching between Fahrenheit and Celsius

1

Press and hold the

-/+

and

Quick Freeze

buttons at the

same time for three seconds to unlock the control panel.

2

Press and hold the

-/+

for three seconds to change

temperature units.

Insignia NS-CZ14XWH7 Quick Setup Guide

Insignia NS-CZ14XWH7 Manual

Insignia NS-CZ14XWH7 manual content summary: