Insignia NS-DWH1WH9 Installation Guide

Insignia NS-DWH1WH9 Manual

Insignia NS-DWH1WH9 manual content summary:

  • Insignia NS-DWH1WH9 | Installation Guide - Page 1
    INSTALLATION GUIDE Top Control Dishwasher NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2BS8 / NS-DWR2WH8 / NS-DWR2SS8 / NS-DWH1SS9 / NS-DWH1WH9 Before using your new product, please read these instructions to prevent any damage.
  • Insignia NS-DWH1WH9 | Installation Guide - Page 2
    7 Cabinet preparation and wire routing 8 Preparing the hot water line 9 Connecting the water line to the water supply 9 Installation instructions 10 Step 1: Check the door balance 10 Step 2: Adjust the leveling legs 10 Step 3: Remove the toekick 11 Step 4: Install to power 11 Step
  • Insignia NS-DWH1WH9 | Installation Guide - Page 3
    reliable and trouble-free performance. This installation guide will show you how to install your new dishwasher. IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK Customer Service at 1-877-467-4289. FOR YOUR SAFETY Read and observe all CAUTIONS and WARNINGS shown throughout these instructions. While
  • Insignia NS-DWH1WH9 | Installation Guide - Page 4
    Top Control Dishwasher READ CAREFULLY. KEEP THESE INSTRUCTIONS. If you have an installation problem, contact your dealer or installer. You are responsible for providing adequate electrical, exhausting, and other connecting facilities. Preparing to install your dishwasher Parts supplied: Wood
  • Insignia NS-DWH1WH9 | Installation Guide - Page 5
    NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2BS8 / NS-DWR2WH8 Materials needed (kit purchased separately): 90° Elbow, ferrule and compression nut. (3/8 NPT external thread on one end. Other end sized to fit water supply line Teflon thread seal tape New installations only Three wire nuts (UL listed) (two
  • Insignia NS-DWH1WH9 | Installation Guide - Page 6
    .) high drain loop will result in improper draining of the dishwasher. Install the waste tee or garbage disposal connection and air gap according to manufacturer's instructions. 6 www.insigniaproducts.com
  • Insignia NS-DWH1WH9 | Installation Guide - Page 7
    to the equipment grounding terminal or lead on the appliance. Grounding Instructions - Power Cord Models This appliance must be grounded. In the in a risk of electric shock. Check with a qualified electrician or service representative if you are in doubt that the appliance is properly grounded.
  • Insignia NS-DWH1WH9 | Installation Guide - Page 8
    Top Control Dishwasher Power Cord Method • Install a 3-prong grounding type receptacle. The wall outlet can be installed in a cabinet or on a wall adjacent to the undercounter space in which the dishwasher is to be installed. • Use power cord kit (part number 5304504505) under Smart Choice brand
  • Insignia NS-DWH1WH9 | Installation Guide - Page 9
    NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2BS8 / NS-DWR2WH8 Preparing the hot water line • The water connection is on the left side of dishwasher. • The hot water line may enter the opening from either side, the rear, or the floor within the shaded area. • The hot water line may pass through the same hole as
  • Insignia NS-DWH1WH9 | Installation Guide - Page 10
    Top Control Dishwasher Installation instructions Step 1: Check the door balance Caution: • Opening the door of your dishwasher before it is installed will cause it to tip forward. Do not open
  • Insignia NS-DWH1WH9 | Installation Guide - Page 11
    NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2BS8 / NS-DWR2WH8 Step 3: Remove the toekick • Remove the two toekick screws with a Phillips screwdriver, then remove the toekick. You'll need: Adjustable wrench Phillips screwdriver Step 4: Install to power Turn off the electricity to the dishwasher's electrical
  • Insignia NS-DWH1WH9 | Installation Guide - Page 12
    junction box cover on the right front of the dishwasher. Be sure that the wires are not pinched under the cover. Note: If you have trouble replacing the junction box cover, loosen the screws on the strain relief. Junction box Ground to green White to white Black to black Junction box
  • Insignia NS-DWH1WH9 | Installation Guide - Page 13
    NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2BS8 / NS-DWR2WH8 Step 5: Install the 90° water supply elbow 1 Wrap the male thread of the 90° elbow with Teflon thread seal tape twice. Do not use plumber's putty. 2 Install the 90° elbow onto the water valve. Do not overtighten the 90° elbow. The water valve bracket
  • Insignia NS-DWH1WH9 | Installation Guide - Page 14
    Top Control Dishwasher Step 6: Install the drain hose 1 Make sure that the leveling feet are loosened before standing the dishwasher upright. They may be tight from shipping/packaging. 2 Turn the dishwasher upright. 3 Slide a screw-type hose clamp onto the right-angled end of the drain hose. 4
  • Insignia NS-DWH1WH9 | Installation Guide - Page 15
    -DWR2WH8 Step 7: Inserting the drain hose through the cabinet • Insert the drain hose into the hole in the cabinet wall. If a power cord is used, guide the end through a separate hole. Tip: Position the water line and house wiring on the floor to avoid interfering with the base of the dishwasher
  • Insignia NS-DWH1WH9 | Installation Guide - Page 16
    Top Control Dishwasher Step 9: Position the dishwasher under the countertop 1 Make sure that the wires are secure under the dishwasher and not pinched or in contact with door springs or other dishwasher components. Tip: Check tub insulation blanket, if equipped. It should be positioned so it is not
  • Insignia NS-DWH1WH9 | Installation Guide - Page 17
    NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2BS8 / NS-DWR2WH8 3 If the door hits the tub, the dishwasher is not installed correctly. Adjust the leveling legs to align the door to the tub. Note: Keep the dishwasher level. Turn the legs to adjust the level You'll need: Adjustable wrench Level Step 11:
  • Insignia NS-DWH1WH9 | Installation Guide - Page 18
    Top Control Dishwasher Method 2 1 Remove the plastic tub caps from the inside of the dishwasher tub. 2 Drive a wood screw through the hole in the side of the dishwasher into the cabinet frame. IMPORTANT: Drive the screws straight and flush. Protruding screw heads will scratch the side if the
  • Insignia NS-DWH1WH9 | Installation Guide - Page 19
    NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2BS8 / NS-DWR2WH8 Step 12: Connecting the water supply line 1 Make sure that you wrapped the 90° elbow with Teflon thread seal tape twice. 2 Slide the compression nut, then the ferrule over the end of the water supply line. Note: If you have a steel-grated line, you
  • Insignia NS-DWH1WH9 | Installation Guide - Page 20
    Top Control Dishwasher 2 If a longer drain hose is required, you can add up to 42" (1.1 m) of length, for a total of 10 ft. (3.01 m) to the factory installed hose. Use 5/8" or 7/8" inside diameter hose and a coupler to connect the two hose ends. Secure the connection with screw-type hose clamps.
  • Insignia NS-DWH1WH9 | Installation Guide - Page 21
    dishwasher to avoid problems or charges for a service call not covered by your warranty. • Make sure that power is turned OFF. • Open the door and remove all foam and paper packaging. • Locate the User Guide in the literature package. • Read the User Guide for operating instructions. • Check the
  • Insignia NS-DWH1WH9 | Installation Guide - Page 22
    dishwasher 1 Turn on the power supply (or plug the power cord into the outlet, if equipped). 2 Turn on your dishwasher (refer to the User Guide for instructions). 3 Close the door, select the Rinse only cycle, and press START/Cancel. 4 Make sure that water enters the dishwasher. If water does not
  • Insignia NS-DWH1WH9 | Installation Guide - Page 23
    Specifications Capacity Dimensions (WxDxH) Weight Power requirements Current Water pressure Noise (dB) NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2BS8 / NS-DWR2WH8 Max 14 place settings (NS-DWH1SS9 / NS-DWH1WH9) Max 16 place settings (NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2WH8 / NS-DWR2SS8 / NS-DWR2BS8) Bar handle
  • Insignia NS-DWH1WH9 | Installation Guide - Page 24
    For product inquiries, please contact us with the information below: 1-877-467-4289 www.insigniaproducts.com INSIGNIA is a trademark of Best Buy and its affiliated companies. Distributed by Best Buy Purchasing, LLC 7601 Penn Ave South, Richfield, MN 55423 U.S.A. ©2018 Best Buy. All rights reserved.
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

Before using your new product, please read these instructions to prevent any damage.
INSTALLATION GUIDE
Top Control Dishwasher
NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2BS8 / NS-DWR2WH8 / NS-DWR2SS8 / NS-DWH1SS9 /
NS-DWH1WH9