Insignia NS-ICETMW3 Quick Setup Guide

Insignia NS-ICETMW3 Manual

Get Insignia NS-ICETMW3 PDF manuals and user guides View all Insignia NS-ICETMW3 manuals
Add to My Manuals
Save this manual to your list of manuals

Insignia NS-ICETMW3 manual content summary:

  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 1
    USER GUIDE Ice Maker for Insignia Top Mount Freezers NS-ICETMW3 Before using your new product, please read these instructions to prevent any damage.
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 2
    water supply 12 Tips for using your automatic ice maker 14 Maintaining your ice maker 14 Troubleshooting 15 Specifications 16 ONE-YEAR LIMITED WARRANTY 17 IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN This symbol indicates that dangerous voltage constituting a risk
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 3
    on the bottom of the ice maker. 7 Refer all servicing to qualified service personnel. Servicing is required when the appliance has been damaged in any way or has been dropped. WARNING Electric Shock Hazard Failure to follow these instructions can result in electric shock, fire, or death. 1 WARNING-Do
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 4
    Package contents Ice maker unit Ice storage bin Water valve Plastic water supply tubing Mounting box Box cover Tube clamp Leveling bracket screw Ice maker mounting Self-tapping screws (2) screws (3) Plastic clamp (3) Plastic clip Short water inlet tube (for 18 cu. ft. freezers) Tools
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 5
    Ice Maker for Insignia Top Mount Freezers Installing the ice maker Your Insignia refrigerator comes set up for ice maker installation. CAUTION: To eliminate the danger of electric shock during installation, you must first unplug the refrigerator. 1 Unplug the refrigerator from the wall outlet. 2
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 6
    4 Peel off the label covering the ice maker hole on the back of the refrigerator, then remove the foam from the hole with the needle nose pliers. Retain the foam for future use. Remove label 5 Push the water inlet tube into the small hole on back of refrigerator. Rotate while inserting the tube
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 7
    Ice Maker for Insignia Top Mount Freezers 7 Squeeze together and slide the tube clamp over the fill tube. While still squeezing the clamp, insert one end of the plastic tube into the fill tube as far as it will go, then slide the clamp downward to capture the fill tube in place. CAUTION: Leaks may
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 8
    9 Use needle nose pliers to remove the terminal cover located at the top of the freezer by first pulling down one side of the cover, then pulling down the other side. Save the terminal cover for future use in case the ice maker is removed. Terminal Terminal cover 10 With the ice maker in one hand,
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 9
    Ice Maker for Insignia Top Mount Freezers 11 Mount the ice maker onto the two ice maker mounting screws you installed in step 8. Make sure that the water inlet tube is sitting inside the fill cup, then tighten the screws. Ice maker mounting screws Water inlet tube Fill cup 12 With the ice maker
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 10
    14 Locate the pre-punched holes at the bottom right corner of the back panel of the refrigerator. Align the water valve bracket with the factory drilled holes, then use a Phillips head screwdriver to drive the two self-drilling screws through the bracket and into the cabinet. Fixing clamps Water
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 11
    Ice Maker for Insignia Top Mount Freezers 16 Grasp the other end of the plastic tube and push it firmly into the quick-connection on the valve until it bottoms out, then insert the plastic clip onto the connector to secure the pipe. Water valve Plastic water supply tubing 17 Clean the back of the
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 12
    is not warranted by the refrigerator or ice maker manufacturer. • Follow these instructions carefully to minimize the risk of water damage. • Water hammer (water banging • The ice maker should be installed by an authorized service technician. • Make sure that the refrigerator is unplugged to
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 13
    Ice Maker for Insignia Top Mount Freezers 8 Tighten the compression nut securely. For plastic tubing, insert the molded end of the tubing into the valve and tighten the compression nut until it is hand-tight, then tighten one additional turn with a wrench. Over-tightening may cause leaks. 9 Place
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 14
    maker Remember that water quality determines the quality of ice. The ice maker should not be connected to softened water. If the water softener has problems, chemical substances can damage the ice maker. To turn off the ice maker, raise the wire signal arm until it locks in the "up" (off
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 15
    Ice Maker for Insignia Top Mount Freezers Troubleshooting CAUTION: Do not try to repair your ice maker yourself. Doing so invalidates the warranty. PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION The ice maker makes no ice The freezer temperature is too high. Make sure that the freezer temperature is
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 16
    PROBLEM The ice smells funny or tastes bad The ice is discolored POSSIBLE CAUSE POSSIBLE SOLUTION The ice storage bin or Empty and wash the ice
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 17
    become the property of Insignia and are not returned to you. If service of Products or parts are required after the Warranty Period expires, not cover: • Food, beverage, and or medicine loss/spoilage • Customer instruction/education • Installation • Set up adjustments • Cosmetic damage • Damage due
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 18
    operation or maintenance • Connection to an incorrect voltage or power supply • Attempted repair by any person not authorized by Insignia to service the Product • Products sold "as is" or "with all faults" • Consumables, including but not limited to batteries (i.e. AA, AAA, C etc.) • Products
  • Insignia NS-ICETMW3 | Quick Setup Guide - Page 19
    www.insigniaproducts.com 1-877-467-4289 (U.S. and Canada) INSIGNIA is a trademark of Best Buy and its affiliated companies. Distributed by Best Buy Purchasing, LLC 7601 Penn Ave South, Richfield, MN 55423 U.S.A. ©2022 Best Buy. All rights reserved. V1 ENGLISH 22-0220
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
Before using your new product, please read these instructions to prevent any damage.
USER GUIDE
Ice Maker for Insignia
Top Mount Freezers
NS-ICETMW3