Insignia NS-LCD37-09 User Manual (English) - Page 17
Legal notices - 1080i
View all Insignia NS-LCD37-09 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Insignia NS-LCD37-09 37" LCD TV Component input HDMI input VGA input Dimensions (with base) Weight Accessories Y: 1 V(p-p), 75 ohm, including sync Pr/Cr: ±0.35 V(p-p), 75 ohm Pb/Cb: ±0.35 V(p-p), 75 ohm Audio: 500 mV(rms) Suggested resolutions: 1080i, 720p, 480p, 480i 3 HDMI input terminal HDCP compliant E-EDID compliant Suggested scan rates: • 1080i • 720p • 480p • 480i D-Sub 15-pin terminal E-EDID compliant Suggested scan rates: • 640 × 480 @ 60 Hz • 800 × 600 @ 60 Hz • 1024 × 768@ 60 Hz • 1360 x 768 @ 60 Hz, Audio input: Headphone mini-jack for stereo 35.75 × 25.04 × 10.24 inches (90.8 × 63.6× 26.0 cm) 35.2 lbs. (16 kg) • Power cord • User guide • Remote control • Batteries (2 AAA) • VGA cable • PC audio cable • Quick Start guide Legal notices FCC Part 15 This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced technician for help. FCC warning Changes or modifications not expressly approved by the party responsible for compliance with the FCC Rules could void the user's authority to operate this equipment. Cables Connections to this device must be made with shielded cables with metallic RF/EMI connector hoods to maintain compliance with FCC Rules and Regulations. Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are trademarks of Dolby Laboratories. www.insignia-products.com 15