Insignia NS-LCD37 User Manual (English) - Page 24
Specifications, Programming the remote, control - remote code
View all Insignia NS-LCD37 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Category Problem Possible Solution Television cabinet creaks Control buttons do not operate • When the television is in use, there is a natural rise in temperature, causing the cabinet to expand or contract and may be accompanied by a slight creaking noise. This is not a malfunction. • Disconnect the power cord and wait for a few seconds. Then re-connect the power cord and turn on the television again. Caution Never attempt to repair a defective television yourself. Note If your problem is not solved, turn your television off and then on again. Specifications Note • • • Design and specifications are subject to change without notice. Weight and dimensions shown are approximate. Specifications and external appearance may be changed for the sake of improvement. Type LCD TV Panel 37-inch TFT LCD TV system American TV standard ATSC/NTSC system Receiving channels VHF 2-13, UHF 14-69, CATV 1-125, CADTV 1-135, DTV 2-69 Audio multiplex BTSC system Audio out 8W x 2 Power requirement AC 120 V. 60 Hz Power consumption 180 W Dimensions 36.7 x 27.5 x 13-inches (931 x 699 x 330 mm) Weight 42 lbs/19 kg Input terminals 2 Composite Video/Audio (L/R) 1 S-video 2 Component Video/Audio (L/R) 2 HDMI interface 1 VGA/Audio 1 Antenna Output terminals 1 Composite Video/Audio (L/R) 1 S/PDIF optical digital audio out 1 headphone jack Control terminals 1 RS-232 Insignia NS-LCD37 LCD TV Programming the remote control Introduction Your remote lets you control four devices with one easy-to-use, compact unit. After installing batteries, you can program the remote to control your VCR or DVD, cable or satellite receivers, amplifier or tuner, and auxiliary devices. To do so, follow the instructions in "Programming a Device" For best results, please read and follow all the remaining instructions. Keep this guide for future reference. Note The universal remote control unit can't be programmed to control a different brand of television. It has been preset to control this television set and this preset is unchangeable. Programming a device To control a VCR or DVD, cable or satellite receiver, amplifier or tuner, and auxiliary device, follow these steps. Before proceeding, find the codes for the devices you want to program in the following tables and write them down or highlight them. Note To program a DVD player, portable DVD player, or mobile DVD player, use the DVD key. To program a device: 1 Turn on the device (for example, the DVD player) and, if needed, load the media (for example, a DVD). 2 Press the DVD, CBL, or AUX button. 3 Press and hold SET until the red LED blinks twice, then release the button. 4 Enter the first five-digit code for your device. The LED blinks once as each digit is entered. If the code is correct, the LED blinks twice. Note If the LED does not blink twice, repeat steps 2 to 4 and try entering the code again. 5 Aim the remote at the device and press Power. The device should turn off. If it does not, repeat steps 3 to 5, trying each code for your brand until you find one that works. If you cannot find a code that works, see "Searching for Your Code" 6 Repeat steps 1 to 5 for the other devices you want to control. For future reference, write down each working device code below: AUX Code: CBL Code: CD Code: DVD Code: SAT Code: TNR Code: VCR Code: 7 Press SET to save your code and exit setup. 22 www.insignia-products.com