Intel DG33TL Product Specification - Page 55
Electrical Considerations
View all Intel DG33TL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Technical Reference 2.5 Electrical Considerations 2.5.1 Power Supply Considerations CAUTION The +5 V standby line from the power supply must be capable of providing adequate +5 V standby current. Failure to do so can damage the power supply. The total amount of standby current required depends on the wake devices supported and manufacturing options. Additional power required will depend on configurations chosen by the integrator. The power supply must comply with the indicated parameters of the ATX form factor specification. • The potential relation between 3.3 VDC and +5 VDC power rails • The current capability of the +5 VSB line • All timing parameters • All voltage tolerances For example, for a system consisting of a supported 65 W processor (see Section 1.4 on page 15 for a list of supported processors), 1 GB DDR2 RAM, one hard disk drive, one optical drive, and all board peripherals enabled, the minimum recommended power supply is 300 W. Table 25 lists the recommended power supply current values Table 26. Recommended Power Supply Current Values Output Voltage 3.3 V 5 V 12 V1 12 V2 Current 15 A 15 A 10 A 10 A -12 V 0.3 A 5 VSB 3.0 A For information about Selecting an appropriate power supply Refer to http://support.intel.com/support/motherboards/desktop/sb/ CS-026472.htm 2.5.2 Fan Header Current Capability CAUTION The processor fan must be connected to the processor fan header, not to a chassis fan header. Connecting the processor fan to a chassis fan header may result in onboard component damage that will halt fan operation. Table 27 lists the current capability of the fan headers. Table 27. Fan Header Current Capability Fan Header Maximum Available Current Processor fan 2.0 A Front chassis fan 1.5 A Rear chassis fan 1.5 A 55