JVC GR-D295U Instructions - Page 19
Zooming, Journalistic Shooting, Time Code, VIDEO RECORDING - camcorder manual
UPC - 046838020049
View all JVC GR-D295U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
VIDEO RECORDING & PLAYBACK Zooming Produces the zoom in/out effect, or an instantaneous change in image magnification. Zoom In Slide the Power Zoom Lever towards "T". Zoom Out Slide the Power Zoom Lever towards "W". ● The further you slide the Power Zoom Lever, the quicker the zoom action. Zoom in (T: Telephoto) 1 xW T 1 0 xW T 20xW T 40xW T Zoom out (W: Wide angle) VIDEO RECORDING EN 19 Journalistic Shooting In some situations, different shooting angles may provide more dramatic results. Hold the camcorder in the desired position and tilt the LCD monitor in the most convenient direction. It can rotate 270° (90° downward, 180° upward). Time Code During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded scene on the tape during playback. Display 10 x W T Digital zoom zone 25X (optical) zoom zone Approximate zoom ratio NOTES: ● Focusing may become unstable during Zooming. In this case, set the zoom while in RecordStandby, lock the focus by using the manual focus (੬ pg. 38), then zoom in or out in Record mode. ● Zooming is possible to a maximum of 800X, or it can be switched to 25X magnification using the optical zoom. (੬ pg. 32) ● Zoom magnification of over 25X is done through Digital image processing, and is therefore called Digital Zoom. ● During Digital zoom, the quality of image may suffer. ● Digital zoom cannot be used when the VIDEO/ MEMORY Switch is set to "MEMORY". ● Macro shooting (as close as approx. 5 cm (2") to the subject) is possible when the Power Zoom Lever is set all the way to "W". Also see "TELE MACRO" in MANUAL Menu on page 33. ● When shooting a subject close to the lens, zoom out first. If zoomed-in in the auto focus mode, the camcorder may automatically zoom out depending on the distance between the camcorder and the subject. This will not occur when "TELE MACRO" is set to "ON". (੬ pg. 33) Minutes Seconds Frames* (30 frames = 1 second) 12 : 34 : 24 * Frames are not displayed during recording. If recording starts from a blank portion, the time code begins counting from "00:00:00" (minute:second:frame). If recording starts from the end of a previously recorded scene, the time code continues from the last time code number. If during recording a blank portion is left partway through the tape, the time code is interrupted. When recording is resumed, the time code starts counting up again from "00:00:00". This means the camcorder may record the same time codes as those existing in a previously recorded scene. To prevent this, perform Recording From The Middle Of A Tape (੬ pg. 20) in the following cases; ● When shooting again after playing back a recorded tape. ● When power shuts off during shooting. ● When a tape is removed and re-inserted during shooting. ● When shooting using a partially recorded tape. ● When shooting on a blank portion located partway through the tape. ● When shooting again after shooting a scene then opening/closing the cassette holder cover. CONTINUED ON NEXT PAGE