JVC KD-AVX44 Instructions - Page 403
Warnings
UPC - 046838031953
View all JVC KD-AVX44 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 403 highlights
KD-AVX44 LVT1798-006A [U/UT] Installation/Connection Manual 0208MNMMDWJEIN EN, CT, TH ©2008 Victor Company of Japan, Limited ENGLISH ˁ̂ ‰∑¬ This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers. 12 V JVC 12 JVC WARNINGS • DO NOT install any unit or wire any cable in a location where; - it may obstruct the steering wheel and gearshift lever operations, as this may result in a traffic accident. - it may obstruct the operation of safety devices such as air bags, as this may result in a fatal accident. - it may obstruct visibility. • DO NOT operate any unit while manipulating the steering wheel, as this may result in a traffic accident. • The driver must not watch the monitor while driving. It may lead to carelessness and cause an accident. • The driver must not put on the headphones while driving. It is dangerous to shut off the outside sounds while driving. • If you need to operate the unit while driving, be sure to look around carefully. • If the parking brake is not engaged, "Parking Brake" appears on the monitor, and no playback picture will be shown. - This warning appears only when the parking brake lead is connected to the parking brake system built in the car. Notes on electrical connections: • Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio dealer. • It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less than 50 W, change "Amplifier Gain" setting to prevent the speakers from being damaged (see page 53 of the INSTRUCTIONS). • To prevent short circuits, cover the terminals of the UNUSED leads with insulating tape. • The heat sink becomes very hot after use. Be careful not to touch it when removing this unit. ᙲѿ Parking Brake Parking Brake" ቁώJVC 50 W 4 Ωü8 Ωé JVC 50 W Amplifier Gain 53 50 W 4 Ω ∂÷ß 8 50 W Amplifier Gain 53 Heat sink ಞᇊ̕ Required space for installation Dashboard Control panel 3 mm/3 mm/ 3 ¡¡. 6 mm/ 6 mm/ 6 ¡¡. Parts list for installation and connection The following parts are provided for this unit. After checking them, please set them correctly A / B Hard case/Control panel C Sleeve ͙ࢭጅೋ D Trim plate ༫ྟख 5 mm / 5 mm / 5 ¡¡. F Crimp connector қʪᏃ G Remote controller ჲ H Batteries ྐЖ E Power cord I Washer (ø5) ࿑ (ø5) 5) Trim plate is detached on this illustration for explanation J Lock nut (M5 M5) M5) K Handles L Rubber cushion M Mounting bolt-M5 x 20 mm M5 x 20 mm M5 x 20 ¡¡. 1