JVC KD-AVX44 Instructions - Page 554

When using the optional stay Fire wall Dashboard Stay (option) Screw (option) 30˚ Install the unit at an angle of less than 30˚. When installing the unit without using the sleeve In a car having the "Required space for installation" (see page 1), first remove the car radio and install the unit in its place. Flat type screws-M5 x 8 mm*2 *2 Not included for this unit. Bracket *2 Bracket *2 Flat type screws-M5 x 8 mm*2 Note: When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are used, they could damage the unit. Removing the unit Before removing the unit, release the rear section. Insert the two handles, then pull them as illustrated so that the unit can be removed. A Connecting the parking brake lead Connect the parking brake lead to the parking brake system built in the car. Parking brake Parking brake switch (inside the car) Parking brake lead (light green) To metallic body or chassis of the car B Connecting the reverse gear signal lead (for rear view camera) (REVERSE GEAR SIGNAL) Locate the reverse lamp lead in the trunk. Extension lead (not supplied) Reverse lamp lead Reverse lamps To reverse lamp Crimp connector (not supplied) To car battery Reverse lamp lead Purple with white stripe TROUBLESHOOTING • The fuse blows. * Are the red and black leads connected correctly? • Power cannot be turned on. * Is the yellow lead connected? • No sound from the speakers. * Is the speaker output lead short-circuited? • Sound is distorted. * Is the speaker output lead grounded? * Are the "-" terminals of L and R speakers grounded in common? • Noise interfere with sounds. * Is the rear ground terminal connected to the car's chassis using shorter and thicker cords? • Unit becomes hot. * Is the speaker output lead grounded? * Are the "-" terminals of L and R speakers grounded in common? • This unit does not work at all. * Have you reset your unit? 2