JVC KD-AVX44 Instructions - Page 628

INSTALLATION (IN-DASH MOUNTING) The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits. • If you are not sure how to install this unit correctly, have it installed by a qualified technician. • Make sure not to block the fan on the rear panel to maintain proper ventilation when installing the unit. • You cannot install the unit on the car which has any obstacles in the space shown in "Required space for installation" on page 1. Caution when installing Fit the unit into the mounting sleeve by using four corners of the trim plate. • DO NOT press the panel (shaded in the illustration). JVC 1 ࡗ JVC 1 *1 When you stand the unit, be careful not to damage the fuse on the rear. *1 *1 ‡ '¬À"¬ Do the required electrical connections Do not block the fan Bend the appropriate tabs to hold the sleeve firmly in place Fit the protrusions outside the unit When using the optional stay Fire wall Dashboard Stay (option Screw (option When installing the unit without using the sleeve In a car having the "Required space for installation" (see page 1), first remove the car radio and install the unit in its place 1 1 Flat type screws-M5 x 8 mm*2 M5 x 8 mm*2 M5 x 8 ¡¡.*2 *2 Not included for this unit. *2 *2 Bracket *2 Ёࣙ *2 2 Bracket *2 Ёࣙ *2 2 Flat type screws-M5 x 8 mm*2 M5 x 8 mm*2 M5 x 8 ¡¡.*2 Note: When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are Install the unit at an angle of less than 30˚. used, they could damage the unit. 30˚ 30 ٍิ: 8 mm 30˚ Õß»" 8 Removing the unit Before removing the unit, release the rear section. Insert the two handles, then pull them as illustrated so that the unit can be removed 2 2