JVC KD-X250BT Instruction Manual - Page 31

Installation/Connection Wiring connection Signal cord*1 MIC (Microphone input terminal) (A page 11) Rear/subwoofer MIC output 10 A fuse JVC Amplifier Rear ground terminal Factory wiring harness (vehicle) Antenna terminal To the steering wheel remote control adapter Light blue/yellow Remote wire*1 D Recommended connection Blue: To power antenna Blue/white: To amplifier Join the same color wires together. Blue/white: Remote (200 mA max.) Orange/white: Illumination Telephone muting (not used) *2 Yellow: 12 V Battery Ignition switch Red: 12 V Ignition switch Black: Ground White: Front speaker (left) White/black Gray: Front speaker (right) Gray/black Green: Rear speaker (left) Green/black Purple: Rear speaker (right) Purple/black Fuse block Separate red wire Make this connection if your vehicle factory wiring harness does not have "12 V ignition switch" wire. Vehicle-specific Wiring Harness (separately purchased) For more information: Metra Electronics: www.metraonline.com Scosche Industries: www.scosche.com *1 Not supplied for this unit. *2 Insulate to prevent short circuit. If you have any troubles, try the following: 1 Check "Troubleshooting" (' page 26). 2 Reset the unit. (' page 3) 3 Contact (USA only) Call: 1-800-252-5722 ( or ) visit: http://www.jvc.com ENGLISH‫ |ޓ‬31