JVC SR-V10U SR-V10U Instruction manual (1MB, PDF) - Page 52

52 EN MULTI-BRAND REMOTE CONTROL (cont.) DBS Receiver Brand Setting This Remote can control some functions of the DBS (Direct Broadcast Satellite) receivers of the brands listed below. 1 Turn on the DBS receiver Turn on the DBS receiver using the Power button on the DBS receiver or its Remote. 2 -14 CABLE/DBS POWER 2 -2 1 2 3 4 5 2 6 2 -3 7 8 9 Number 0 4 2 Enter DBS receiver brand code Follow the example shown below. 1 Press and hold CABLE/DBS. 2 Press MBR SET. 3 Press the Number keys to enter your DBS receiver's brand code by referring to the table below. 4 Press OK, and release CABLE/DBS. The DBS receiver should turn off. If it does, try other operations below (੬ step 3). ● Once you have set the Remote to operate the DBS receiver, you do not have to set it until you replace the batteries from the Remote. 3 Operate DBS receiver 1 While holding down CABLE/DBS, press one of the following buttons: POWER, TV CH +/-, and Number keys. 3 2 -4 ENTER TV CH +/- ● For some brands, you must press ENTER after having pressed the Number keys to enter a channel number. ● To change the DBS receiver's channels, press TV CH +/- or the Number keys. (The CH +/- button can be used to change the VCR's channels only.) DBS BRAND NAME JVC (DISH Network) ECHOSTAR (DISH Network) PRIMESTAR SONY (DSS) RCA (DSS) BRAND CODE 51 51 50 41 40 NOTES: ● Depending on the type of DBS receiver, some or all functions cannot be operated using this Remote. ● It's not possible to operate a DBS receiver not equipped with a remote sensor. ● It's not possible to set the Remote for both your DBS receiver and a cable box at the same time. You can only set the Remote to operate one of these units at a time. (Ex.) To set the Remote to JVC 51: CABLE/ DBS MBR SET A/B 5 ENTER/OSD 1 3 OK Release Hold down Press in succession