JVC SR-V10U SR-V10U Instruction manual (1MB, PDF) - Page 53
Changing, Remote Control
View all JVC SR-V10U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Changing Remote Control Code 2 POWER S VIDEO VIDEO (MONO)L-AUDIO-R REC LINK DIGITAL TBC/NR SP EP VCR A.DUB INSERT PLAY REW - FF + CH- /+ PUSH / TURN 24HR QUICK PROGRAM REC PAUSE STOP/EJECT 1 -1, 3 1 2 3 4 5 2 6 1 -2 7 8 9 0 4 1 EN 53 This Remote is capable of transmitting two control codes; one set to respond to A code control signals and another set to respond to B code control signals. This Remote control is preset to send A code signals because your VCR is initially set to respond to A code signals. You can easily modify your VCR and the Remote to respond to B code control signals. When using two JVC VCRs, set two VCRs and their Remotes to different codes, so that you can operate these VCRs separately. 1 Set remote control code for Remote 1 Press and hold A/B. 2 Press the Number key "2". 3 Press OK, and release A/B. ● The Remote now can transmit B code control signals. 2 Check remote control code for VCR Press and hold PLAY ( 3 ) on the VCR for more than 5␣ seconds while the VCR is turned off. The code currently set appears on the display panel. 3 Change code for VCR Press any key on the Remote. ● The VCR now responds to B code control signals. ● To set the Remote and the VCR back to A code control signals, repeat the same procedure as shown above except pressing the Number key "1" in step 2 of 1. To control two VCRs with the same Remote You can control two JVC VCRs by switching the remote control code for the Remote between A and B (੬ step 1), keeping two VCRs to different control codes. ● Press the Number key "1" for A code control signals and the Number key "2" for B code control signals. (To change only the remote control code for the Remote, DO NOT perform steps 2 and 3 .) 3 1 -3 (Ex.) To set Remote to B code: MBR SET A/B 2 ENTER/OSD 3 OK Release Hold Press in succession down