Jabra GN9350 User Manual - Page 6

2. Setting up This section contains set-up and connection instructions for your headset's accessories and optional functions. Note: Your Guide for basic set-up and use contains the primary set-up and connection instructions. GN9350e GN9330e GN9330e USB 2.1 Headset port If your telephone has a port for headset, it is recommended to leave the handset cord in the telephone. Connect the telephone's headset port to the telephone port on the base. This will enable you to use the call button on your telephone, if there is one, and will limit the number of cords coming out of your base. Important: The "clear dial tone switch"must be positioned correctly. See section: "Clear dial tone adjustment" in the Quick Start Guide or the online Flash video at www.jabra.com. GN9350e GN9330e GN9330e USB 2.2 Default Outbound Call mode The base is default set for telephone use. If you want to use your VoIP application as default calling media, press the USB button for 5 seconds. If you want to change it back again, press the Telephone button for 5 seconds GN9350e GN9330e GN9330e USB 2.3 Connecting to the GN1000 RHL (Remote Handset Lifter) (GN accessory) You may purchase a GN1000 RHL as an accessory, which lets you answer and end telephone calls while away from your desk. Please contact your vendor or visit www.jabra.com for further details. To connect your GN1000: 1. Mount the GN1000 to your telephone as described in its user manual. 2. Plug RHL's connection cord into headset base's AUX port. The GN9350e enables you to use electronic hookswitch (EHS) to answer and end calls while away from your desk. Feature is described in section 2.5.2. The remote answering and ending of calls is also available on certain softphone/VoIP applications. 4 GN9350e GN9330e GN9330e USB 2.4 LCD display Your base unit has a LCD display and display control with which you control 5 settings: Transmit volume setting Hookswitch selection Range/power selection Sound mode selection Protection level selection (IntelliTone®) Navigation and markers Navigate through the LCD display's 5 menus horizontally using the display control's34arrows. Within each of the 5 menus, navigate vertically with the display control's 56arrows. Press the OK button to confirm a specific choice/value within the 5 different menus. A star (*) beside a selected choice/value indicates the current setting. Default/start position The LCD display is always on and ready to use. The permanent default/start position for the LCD display is the leftmost transmit volume setting . The LCD display will always revert to this default/start position, if not operated for 30 seconds. Within each of the 5 menus, there is also a factory-set default. This default remains until you change it. The last selected choice/value (within each of the 5 menus) is always displayed in the first line of its menu. Changing the settings 2.4.1 Transmit volume The transmit volume must be adjusted properly so your voice is heard clearly. If you haven't already adjusted the transmit volume during your initial setting up, do so now by completing the following: 1. Put on headset. 2. Use 34to locate transmit volume menu on base display. 3. Make a call to someone who will act as a test person. 4. Use 56 to scroll through 12-setting transmit volume menu until your test person confirms your voice is at the appropriate volume. 5. Press OK to confirm new setting. The transmit volume menu is the permanent default/start position for the LCD display. After adjusting any of the other settings via the display, it will revert to the transmit volume menu position. Important: For USB applications, the volume settings are fixed and need no adjustment. 5