Jabra GN9350 User Manual - Page 7

2.4.2 Hookswitch selection The GN9350e enables you to answer and end calls remotely by using the GN1000 RHL, or its built-in electronic hookswitch (EHS) modes. EHS is only possible on certain telephone systems. In order to determine which telephones have the EHS feature enabled, please refer to our website www.jabra.com. Please also refer to your telephone´s user manual for clarification. 4 modes are available GN RHL (Default) DHSG AEI MSH non-EHS; works with the GN1000 RHL e.g. Siemens, Elmeg, Cisco, Avaya, and Polycom desk telephones e.g. with Tenovis desk telephones e.g. with Alcatel desk telephones Note: By default, the GN9350e is set to the RHL interface, which also is the correct setting if you manually operate your handset when answering/ending calls as described in the Guide for basic set-up and use. To select the appropriate interface: 1. Use 34to locate the hookswitch selection menu on base display. 2. Use 56 to select one of the 4 interfaces from the menu. 3. Press OK to confirm the interface. Note: To use the DHSG, AEI or MSH function, connect the connection cord (accessory) to your desk telephone and the AUX port of the GN9350e. 2.4.3 Range/power selection Your headset offers 3 range/power modes (Normal, Low and Very Low). The Normal mode is ideal for most users. However, if you experience interference from other communication devices during your calls, you may want to switch to the Low or Very Low modes. Changing to Low or Very Low power modes will reduce the range of your headset. Power mode Range* DECT Normal (Default) Up to 120 m Low Up to 60 m Very Low (V. low) Up to 25 m * In typical office environment Note: The Normal power mode is the default setting. Range* US DECT Up to 400 ft Up to 200 ft Up to 80 ft 6 To change the range/power mode: 1. Use 34to locate the range/power mode menu on base display. 2. Use 56 to select one of the 3 modes from the menu. 3. Press OK to confirm the new mode. 2.4.4 Sound mode selection This menu is split into two sections:"Treble/Normal/Bass"and"Fixed/Switch". These two sections are separated by a blank line. It is possible to choose one mode in each of the two sections. Your headset offers 3 treble/bass modes (Treble, Normal and Bass). You can change these to suit your personal preferences or needs, and seperately determine the USB sound quality. Sound mode Treble Normal (Default) Bass Effect Accentuates high tones Accentuates all tones evenly Accentuates lower tones Benefits Ideal for users with slight highfrequency hearing loss Ideal for all users Ideal for users preferring a bass-rich sound Sound mode Fixed Switch (Default) Effect Speech quality in headset loudspeaker as known from traditional telephones (narrowband) Automatically switches between wideband or narrowband sound quality. In conference call mode, automatic switching is disabled. Benefits - Improved talk time in USB mode - Faster radio link - More units in a given area Enhanced USB sound quality Note: The Normal mode is the default setting. For high density deployments, or if there are difficulties or delay acquiring a radio link, it is recommended to change sound mode from 'switch'to 'fixed'. On the GN9350e, CARB+ can be enabled to offer an additional +6 dB of transmit gain (typically used with carbon based phones). Sound mode Effect Benefits CARB+ Additional + 6dB transmit gain Higher transmit volume To change the sound mode: 1. Use 34to locate the sound mode menu on base display. 2. Use 56 to select one of the 3 modes from the menu, and choose between fixed/switched from the menu. 3. Press OK to confirm the setting. 7