Jenn-Air JDRP430WP Dimension Guide

30" (76.2 CM), 36" (91.4 CM) AND 48" (121.9 CM)

COMMERCIAL STYLE DUAL FUEL CONVECTION RANGES

PRODUCT MODEL NUMBERS

PRODUCT DIMENSIONS

GAS SUPPLY REQUIREMENTS

To properly install your range, you must determine the type of electrical connection

you will be using and follow the instructions provided for it here.

●

Range must be connected to the proper electrical voltage and frequency as specified

on the model/serial number rating plate. The model/serial number rating plate is

located under the console on the right-hand side. Refer to the figures in the

“Product Dimensions” section of the “Location Requirements” section.

●

This range may be manufactured with a 4-wire power supply cord or may not

include a power supply cord. If your range does not include a power supply cord,

use a 4-wire power supply cord rated at 250 volts, 40 or 50 amps and investigated

for use with ranges.

Range Rating*

Specified Rating of Power Supply

Cord Kit and Circuit Protection

120/240 Volts

120/208 Volts

Amps

Range Size

8.8 - 16.5 KW

7.8 - 12.5 KW

40 or 50**

30" (76.2 cm),

36" (91.4 cm)

16.6 - 22.5 KW

12.6 - 18.5 KW

50

48" (121.9 cm)

*

*

The NEC calculated load is less than the total connected load listed on the

model/serial rating plate.

**

If connecting to a 50-amp circuit, use a 50-amp rated cord with kit. For 50-amp

rated cord kits, use kits that specify use with a nominal 1

³⁄₈

" (34.9 mm) diameter

connection opening.

●

A circuit breaker is recommended.

●

Wire sizes and connections must conform with the rating of the range.

Because Whirlpool Corporation policy includes a continuous commitment to improve

our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation

Instructions packed with product. Specifications subject to change without notice.

Ref. W10349768A

1/4/11

Type of Gas

Natural Gas:

This range is design-certified by CSA International for use with Natural gas or, after

proper conversion, for use with LP gas.

●

This range is factory set for use with Natural gas. The model/serial rating plate

located under the console on the right-hand side has information on the types of

gas that can be used. If the types of gas listed do not include the type of gas

available, check with the local gas supplier.

LP Gas conversion:

Conversion must be done by a qualified service technician.

No attempt shall be made to convert the range from the gas specified on the

model/serial rating plate for use with a different gas without consulting the serving

gas supplier. To convert to LP gas, use the LP gas conversion kit provided with your

range and see the “Gas Conversions” section. The parts for this kit are in the literature

package supplied with the range.

Gas Supply Line

●

Provide a gas supply line of

³⁄₄

" (1.9 cm) rigid pipe to the range location. A smaller

size pipe on longer runs may result in insufficient gas supply. With LP gas, piping or

tubing size can be

¹⁄₂

" (1.3 cm) minimum. Usually, LP gas suppliers determine the

size and materials used in the system.

NOTE:

Pipe-joint compounds that resist the action of LP gas must be used. Do not

use TEFLON

®†

tape.

†®

TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.

JDRP430W

JDRP436W

JDRP536W

JDRP548W

ELECTRICAL REQUIREMENTS - U.S.A. ONLY

Page 1 of 2

B

C

A

E

D

30" (76.2 cm) models

ELECTRICAL REQUIREMENTS - CANADA ONLY

●

Check with a qualified electrical installer if you are not sure the range is properly

grounded.

●

When a 4-wire, single phase 250 volt, 60 Hz., AC only electrical supply is available, a

40-amp minimum circuit protection is required on 30" (76.2 cm) and 36" (91.4 cm)

ranges and a 50-amp minimum circuit protections is required on 48" (121.9 cm)

ranges, fused on both sides of the line.

●

A time-delay fuse or circuit breaker is recommended.

●

This range is equipped with a CSA International Certified Power Cord intended to be

plugged into a standard 14-50R wall receptacle. Be sure the wall receptacle is within

reach of range’s final location.

●

Do not use an extension cord.

LOCATION REQUIREMENTS

Mobile Home - Additional Installation Requirements

The installation of this range must conform to the Manufactured Home

Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the

Federal Standard for Mobile Home Construction and Safety, Title 24, HUD

Part 280). When such standard is not applicable, use the Standard for

Manufactured Home Installations, ANSI A225.1/NFPA 501A or with local

codes.

In Canada, the installation of this range must conform with the current

standards CAN/CSA-A240-latest edition, or with local codes.

Mobile home installations require:

●

When this range is installed in a mobile home, it must be secured to

the floor during transit. Any method of securing the range is adequate

as long as it conforms to the standards listed above.

Jenn-Air JDRP430WP Dimension Guide

Jenn-Air JDRP430WP Manual

Jenn-Air JDRP430WP manual content summary: