Jenn-Air JDS9860CDS Use and Care - Page 27
Oven Lights, Oven Door
View all Jenn-Air JDS9860CDS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Filter The filter is a permanent type and should be cleaned when soiled. Cleaning Method: ■ Turn off the downdraft ventilation system before removing the filter. ■ Remove vent grate then lift the filter out of the vent chamber. should rest against the right side of the vent chamber at the bottom. If the filter is flat against the fan wall, ventilation effectiveness will be reduced. ■ Clean the filter in the sink with warm water and detergent or in the dishwasher. ■ Replace the filter. The filter should always be placed at an angle. As you face the front of the range, the top of the filter should rest against the left side of the vent opening. The bottom of the filter Ventilation Chamber The ventilation chamber, which houses the filter, should be cleaned in the event of spills or when it becomes coated with a film of grease. Cleaning Method: ■ Mild household detergent or cleanser and paper towel, damp cloth or sponge: Apply detergent or cleanser to paper towel, damp cloth or sponge, not directly to the ventilation chamber. Oven Lights The oven uses a 120-volt, 20-watt maximum halogen bulb. See the "Assistance or Service" section to order. Ask for Part Number 74004458. To Replace Oven Light: Before replacing, make sure the oven is off and cool. 1. Unplug range or disconnect power. 2. Use fingertips to grasp edge of bulb cover. Pull out and remove. 3. Remove bulb from socket by pulling straight out of the ceramic base. 4. Replace bulb, using tissue or wearing cotton gloves to handle bulb. To avoid damage or decreasing the life of the new bulb, do not touch bulb with bare fingers. 5. Replace bulb cover by snapping back into place. 6. Plug in range or reconnect power. Oven Door For normal range use, it is not suggested to remove the oven door. However, if removal is necessary, make sure the oven is off and cool. Then, follow these instructions. The oven door is heavy. To Replace: 1. Grasp door at each side. 2. Align slots in the door with the hinge arms on the range. To Remove: 1. Open oven door to the first stop position (opened about 4" [10.0 cm]). 2. Grasp door at each side. Do not use the door handle to lift door. 3. Slide the door down onto the hinge arms until the door is completely seated on the hinges. Push down on the top corners of the door to completely seat door on hinges. Door should not appear crooked. 3. Lift up evenly until door clears hinge arms. 27