Kenmore 2806 Use and Care Guide - Page 12

jthe

Page 12 highlights

Load evenly to maintain washer balance. Mix large and small items. For best performance, load garments in loose heaps evenly around the basket wall. Do not load above the stainless steel portion of the basket, as shown. 2= Pour measured powdered or liquid High Efficiency (HE) detergent into the detergent dispenser. Do not put detergent directly into the wash tub or onto clothes in the washer. • The fabric softener is dispensed in the rinse cycle. If 2nd Rinse is selected, the fabric softener will be dispensed during the 2nd Rinse. • Do not use fabric softener dispensing balls in this washer. Dispensing balls will not operate correctly with this washer. • Do not spill or drip any fabric softener onto the clothes. • At the end of the cycle, a small amount of water may be left in the dispenser. This is normal. NOTE: Use only liquid fabric softener in this dispenser. 5. Close the washer lid. 6. Press POWER. This turns on the washer display. 7. Select a Wash Cycle. See "Cycles." 8. Adjust the Modifiers, if desired. See "Modifiers." 9. Select desired Options. See "Options." 10. Select Delay Start, if desired. See "Delay Start" in the "Modifiers" section. 11. Press START. The wash cycle begins, and the display shows the estimated remaining time. The lid will lock. NOTE: If you do not press Start within 5 minutes of pressing Power, the washer automatically shuts off. 3= Add liquid chlorine bleach to the bleach dispenser, if needed. Chlorine bleach is automatically dispensed at the proper time during the wash cycle. • Do not overfill. Do not dilute. Do not use more than 1 cup (250 ml) for a full load. Use less with a smaller load size. • Follow the garment and chlorine bleach manufacturer's directions for proper use. • To avoid spilling, use a cup with a pouring spout. Do not let bleach splash, drip, or run down into the washer basket. • At the end of the cycle, a small amount of water may be left in the dispenser. This is normal. 4= Pour measured liquid fabric softener into the fabric softener dispenser, if desired. • If you are using fabric softener, be sure to select Fabric Softener from the options to assure proper dispensing. • Do not overfill. Do not dilute. The dispenser holds 3 oz (94 mL), or a capful of fabric softener. 12 Add A Garment You can place additional clothing in the wash when the "Add A Garment" status light is glowing without sacrificing wash performance. To add a garment or pause the washer at any time 1. Press STOP once. 2. Wait until the Lid Lock light turns off, then open the lid. 3. Add items. To restart the washer 1. Close the lid and press START. 2. To unlock the lid after the Add A Garment period, press STOP once. Pressing STOP twice will cancel the wash cycle. opp 9j the sse You can stop the wash cycle and drain the tub by pressing the STOP button twice or the POWER button once. ° ° __ _ _ • _s i_ ,_ e You can change Cycles, Modifiers, and Options anytime before Start is pressed. Not all Modifiers and Options are available for all cycles. • A short tone sounds when a change is selected. • Three short tones sound if an unavailable combination is selected. The last selection will not be accepted. Changing Cycles during the wash cycle 1. Press STOP twice to cancel the cycle. The washer will drain. 2. Press POWER. 3. Select the desired wash cycle. 4. Select the desired Modifiers and Options. 5. Press START. The washer restarts at the beginning of the new cycle. NOTE: If you do not press Start within 5 minutes of pausing the washer, the washer automatically shuts off.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76

2=
3=
4=
Load evenly to maintain washer
balance.
Mix large and
small items.
For best performance,
load garments
in loose heaps
evenly around
the basket wall. Do not load above the
stainless
steel portion
of the basket, as shown.
Pour measured
powdered
or liquid High Efficiency
(HE)
detergent
into the detergent
dispenser.
Do not put detergent
directly
into the wash tub or onto clothes
in the washer.
Add liquid chlorine
bleach to the bleach dispenser,
if needed.
Chlorine
bleach is automatically
dispensed
at the proper time
during the wash cycle.
Do not overfill. Do not dilute. Do not use more than 1 cup
(250 ml) for a full load. Use less with a smaller
load size.
Follow the garment
and chlorine
bleach manufacturer's
directions
for proper use.
To avoid spilling,
use a cup with a pouring
spout.
Do not
let bleach splash,
drip, or run down
into the washer
basket.
At the end of the cycle, a small amount
of water
may be
left in the dispenser.
This is normal.
Pour measured
liquid fabric softener
into the fabric softener
dispenser,
if desired.
If you are using fabric softener,
be sure to select Fabric
Softener
from the options
to assure proper
dispensing.
Do not overfill. Do not dilute. The dispenser
holds 3 oz
(94 mL), or a capful of fabric softener.
The fabric softener
is dispensed
in the rinse cycle. If 2nd
Rinse is selected,
the fabric softener
will be dispensed
during the 2nd Rinse.
Do not use fabric softener
dispensing
balls in this washer.
Dispensing
balls will not operate
correctly
with this
washer.
Do not spill or drip any fabric
softener
onto the clothes.
At the end of the cycle, a small amount
of water may be
left in the dispenser.
This is normal.
NOTE: Use only liquid fabric softener
in this dispenser.
5.
Close the washer
lid.
6.
Press POWER. This turns on the washer
display.
7.
Select a Wash Cycle. See "Cycles."
8.
Adjust the Modifiers,
if desired. See "Modifiers."
9.
Select desired Options.
See "Options."
10. Select Delay Start, if desired.
See "Delay Start"
in the
"Modifiers"
section.
11. Press START. The wash cycle
begins,
and the display
shows
the estimated
remaining
time. The lid will lock.
NOTE: If you do not press Start within 5 minutes
of pressing
Power, the washer automatically
shuts
off.
Add A Garment
You can place additional
clothing
in the wash when the "Add A
Garment"
status light is glowing
without
sacrificing
wash
performance.
To add a garment
or pause
the washer
at any time
1.
Press STOP once.
2.
Wait until the Lid Lock light turns off, then open the lid.
3.
Add items.
To restart
the washer
1.
Close the lid and press START.
2.
To unlock the lid after the Add A Garment
period, press STOP
once. Pressing
STOP twice will cancel
the wash cycle.
opp
9jthe
sse
You can stop
the wash cycle and drain the tub by pressing the
STOP button twice
or the POWER button once.
°
°
__
_
_
•_s¸ _,._'_
__
_i_ ,_ e
You can change Cycles,
Modifiers,
and Options
anytime
before
Start is pressed.
Not all Modifiers
and Options
are available for all
cycles.
A short tone sounds
when
a change is selected.
Three short tones sound
if an unavailable
combination
is
selected.
The last selection
will not be accepted.
Changing
Cycles
during
the wash
cycle
1.
Press STOP
twice to
cancel
the
cycle.
The washer will
drain.
2.
Press POWER.
3.
Select the desired wash cycle.
4.
Select the desired Modifiers
and Options.
5.
Press START.
The washer
restarts
at the beginning
of the new cycle.
NOTE: If you do not press Start within 5 minutes
of pausing
the
washer, the washer
automatically
shuts
off.
12