Kenmore 2806 Use and Care Guide - Page 6
Installation Instructions - appliances
View all Kenmore 2806 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Floor drain system (view D) The floor drain system requires a siphon break that may be purchased separately. See "Tools and Parts." The siphon break must be a minimum of 28" (71 cm) from the bottom of the washer. Additional hoses might be needed. C D Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. • A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit serving only this appliance be provided. • This washer is equipped with a power supply cord having a 3 prong grounding plug. To minimize possible shock hazard, the cord must be plugged into a mating, grounded 3 prong outlet, grounded in accordance with local codes and ordinances. If a mating outlet is not available, it is the personal responsibility and obligation of the customer to have the properly grounded outlet installed by a qualified electrician. • If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. • Do not ground to a gas pipe. • Check with a qualified electrician if you are not sure the washer is properly grounded. • Do not have a fuse in the neutral or ground circuit. GROUNDING iNSTRUCTiONS For a grounded, cord-connected washer: This washer must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electrical shock by providing a path of least resistance for electric current. This washer is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. WARNING: Improper connection of the equipmentgrounding conductor can result in a risk of electric shock, Check with a qualified electrician or serviceman if you are in doubt as to whether the appliance is properly grounded, Do not modify the plug provided with the appliance - if it will not fit the outlet, have a proper outlet installed by a qualified electrician. For a permanently connected washer: This washer must be connected to a grounded metal, permanent wiring system, or an equipment grounding conductor must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the appliance. INSTALLATION INSTRUCTIONS Excessive Weight Hazard Use two or more people to move and install washer. Failure to do so can result in back or other injury. IMPORTANT: • Be sure the foam shipping base has been removed from the bottom of the washer as directed in the Unpacking Instructions. • If foam shipping base has not been removed, be sure lid is secured with tape before laying washer on its back. • Removing the foam shipping base is necessary for proper operation. NOTE: To avoid floor damage during installation, set the washer onto cardboard before moving across floor. 1. Place cardboard supports from shipping carton on floor behind washer for support. 2. Secure the lid with tape. 6