Kenmore 32184 Owners Manual - Page 20
Drain Valve Washer, Replacement, Anode, Rod Inspection
View all Kenmore 32184 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Service and Adjustment (cont'd) Element Cleaning/ Replacement (cont'd) 716. Replace the terminal cover on thermostat, This does not affect the water's vaste or color. The rod must be maintained to keep the tank in operating condition, Anodc dctcrioration dcpcnds on watcr conducti_4t); not ncccssarily _atcr condition, A corrodcd or pittcd anodc rod indicates high watcr conducti_49T and should be chcckcd and/or rcplaccd morc often than an anodc rod that appcars to bc intact. Rcplaccmcnt ofa dcplctcd anodc rod can cxtcnd thc li_ of your _atcr hcatcr. Inspection should be conducted by"a Scars scr_4cc tcchrddan, and at a minimum shotfld be chcckcd annually aftcr the _arran_ period, 17. Replace the insulation block and pad so that it complctdy covers the thermostat and clement. Drain Valve Washer Replacement NOTE: For replacemeut_ use a r_, _ x v:_Yutt x 1__ tM.ck washer available at your nearest hardware store. For ordering a replacement washer_ refer to the "Parts Order Lis_' se_-iom • Be_rc bcginning turn _OFF" the clectrica,1power supply to the water heater, ] 8. Replace access pancl. 19. Turn "ON" electric power to water heater. AWARNING .I HAZARD OF ELECTRICAL SHOCKI Before removing any access panels or servicMg the water heater, make I sure the electrical supply to the water heate_ _sturned I "OFF". Failure to do this could result _n DEATH_ SERI- OUS BOD LY NJUR_ OR PROPERTY DAMAGE. • Follow "Draining" instructions in the _Scrvicc and Adjustment" section. • Turning counter clockwise, remove the hcx cap below the screw-handle, • Remove the _ashcr and put the new-one in placc. •Scrcw¢ the handle and cap assembly back into the drain vdvc and rctightcn t_sing awmnch, DO NOT OVER TIGHTFN. • Follow _Filling thc Watcr Hcatcr" instructions in thc qnsvallation Instructions" scction, • Chc& for leaks. • Turn "ON" dectric power to the _atcr heater, _ HANDLI= AND _, CAUTION . Neve_ use this wate_ heate_ unless it is completely full orI water. To prevent daumageto the tank and heating element, I the tank must be filled with water. Water must flow from the hot water faucet before turn ng ON' power. Anode Rod Inspection The anode rod is used to protect the yank from corrosion. Most hot watcr tanks arc cquippcd with an anode rod. Thc submerged rod sacrifices itsdf'to protect the tank. Instead of'corroding the yank water ions attack and cat away the anode rod, 2O Service Before calling for repair sctMcc, mad thc Start Up Conditions and Operational Conditions fbund in the Troubleshooting Guide of'this manual, If'a condition persists or you arc uncertain about thc opcratton ofthc watcr hcatcr,lct a qualificd pcrson chcck it out. Contact SEARS Repair Services at 1-800-4-MY-HOME (1-800_i69-4663),