Kenmore 6593 Use and Care Guide - Page 8
Door Removal
View all Kenmore 6593 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
3. Using hex head driver, turn the front adjustment screws (A) on each side to raise or lower the front of the refrigerator. B 4_ Using the carpenter's level, make sure front of refrigerator is '/_" (6 ram) or '/_bubble higher than back of refrigerator and that the refrigerator is level from side to side. Turn stabilizing legs (B) clockwise until firmly against floor. Replace hinge cover(s). • Position cover into the outer edge of the hinge. • Swing the cover toward the cabinet and snap it into place. 7. Replace the toe grille. Note For proper reinstallation, ensure the "top" marking on the interior of the toe grille is oriented correctly. • Align the toe grille mounting clips with the lower cabinet slots. • Push the toe grille firmly until it snaps into place. Door Removal Some installations require door removal to transport the refrigerator to its final location. To avoid electrical shock which can cause severe personal injury or death, observe the following: • Disconnect power to refrigerator before removing doors. Connect power only after replacing doors. To avoid damage to walls and flooring, protect vinyl or other flooring with cardboard, rugs or other protective material. MateriaJs Needed: • Phillips screwdriver • %" hex head driver Unplug power cord from power source. Remove toe grille (see page 7). 3_ Remove top hinge cover from refrigerator door by removing Phillips screw and retain screw and cover for later use. ZIt_ Unscrew -%6"hex head screws from top hinge to remove hinge and retain all screws for later use. Lift refrigerator door from center hinge pin. Hold freezer door while removing hinge pin with a -%?'hex head drivel. Remove door from bottom hinge and retain hinge pin for later use. Remove any door shims if present. Remove Phillips screws to remove center hinge and retain all screws for later use. 8. Remove bottom hinge or stabilizing bracket with _" hex head driver and retain screws for later use. Lift out bottom hinge pin.