Kenmore HE3t Use and Care Guide - Page 6
Location Requirements - washer filling with water when off
View all Kenmore HE3t manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Location Requirements Selecting the proper location for your washer improves performance and minimizes noise and possible washer "walk." Your washer can be installed under a custom counter, or in a basement, laundry room, closet, or recessed area. See "Drain System." Companion appliance location requirements should also be considered. Proper installation is your responsibility. Recommended installation spacing for custom undercounter installation The dimensions shown are for the recommended spacing. Custom undercounter installation - Washer only You will need s A water heater set to deliver 120°F (49°C) water to the washer. 39" min. (99.0 cm) s A grounded electrical outlet located within 6 ft (1.8 m) of where the power cord is attached to the back of the washer. See "Electrical Requirements." 1" (2.5 cm) 27" (68.6 cm) 1" (2.5 cm) s Hot and cold water faucets located within 4 ft (1.2 m) of the hot and cold water fill valves, and water pressure of 20-100 psi (137.9-689.6 kPa). s A level floor with a maximum slope of 1" (2.5 cm) under entire washer. Installing the washer on soft floor surfaces, such as carpets or surfaces with foam backing, is not recommended. s A sturdy and solid floor to support the washer with a total weight (water and load) of 400 lbs (180 kg). Do not operate your washer in temperatures below 32°F (0°C). Some water can remain in the washer and can cause damage in low temperatures. Installation clearances s The location must be large enough to allow the washer door to be fully opened. Recommended installation spacing for recessed or closet installation, with or without a pedestal The dimensions shown are for the recommended spacing. Recessed area or closet installation 34" (86.4 cm) 48 in.2 * (310 cm2) 3" (7.6 cm) 24 in.2 * (155 cm2) 1" 31¹⁄₂" 4" (2.5 cm) (80 cm) (10.2 cm) 3" (7.6 cm) s Additional spacing should be considered for ease of installation and servicing. s Additional clearances might be required for wall, door, and floor moldings. s Additional spacing of 1" (2.5 cm) on all sides of the washer is recommended to reduce noise transfer. A B A. Side view - closet or confined area B. Closet door with vents *Min. top and bottom air openings for closet door. Recessed or closet installation - Washer on pedestal s Companion appliance spacing should also be considered. Washer Dimensions 18" min. (45.7 cm) 50¹⁄₂" (128.3 cm) 27" (68.6 cm) 38" (96.5 cm) 31¹⁄₂" (80.0 cm) 1" (2.5 cm) 27" (68.6 cm) A 1" (2.5 cm) 1" 31¹⁄₂" 4" (2.5 cm) (80 cm) (10.2 cm) B A. Recessed area B. Side view - closet or confined area 6