Kenwood DDX6019 Instruction Manual - Page 70
Security Code Setup - protect
UPC - 019048166913
View all Kenwood DDX6019 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Before Use Security Code Setup You can set a security code to protect your receiver system against theft. 2 Start the security code registration Set • The Security Code can be set as the 4 digit number of your choice. 1 Display the Security Code Setup screen Security If Security touch or is not shown, to display it. 3 2 Security Code Set 4 SI 5 On Of f 5 1 Pass Word 1 1 4 7 2 Clear 1st 2 3 5 6 8 9 0 3 Cancel 4 Enter 1 Enters the numbers to make your security code. 2 Clears your entry. 3 Cancels the registration and returns to the Security Code Setup screen. 4 Registers your security code. 3 Enter a security code Security 1 Returns to the Control screen of the previous source. 2 Calls the Sound Effects Menu. (page 76) 3 Calls the Setup Menu. (page 56) 4 Allows you to start security code registration. 5 Turns the SI function On or Off. If turned "On", the burglar alarm lamp flashes when the vehicle ignition is off. ( On) • If you have already completed the code registration, C L R is displayed. 0 -9 Input by four-digit number. 4 Register your security code Enter 5 Reenter the security code Reenter the same security code as that you have entered in Step 3 for confirmation. • If you enter a different security code, the screen returns to Step 3 (for the first code entry). 6 Register the security code again Enter Now, your security code is registered. If you press the Reset button or if you disconnect your receiver from the battery after the code registration, you need to enter the registered security code. See below for details. 70 | English