Kenwood KDC X493 Instruction Manual - Page 33

⁄ • You cannot Channel search until the category information is acquired. Preset Memory Putting the channel in the memory. 1 Select the channel to put in the memory Push the [AUD] knob towards right or left. 2 Enter Preset Memory mode Press the [SEARCH] button. 3 Select the number to put in the memory Turn the [AUD] knob or push it towards up or down. 4 Determine the number to put in the memory Press the [AUD] knob
for at least 1 second. Cancelling the Preset Memory mode Press the [SEARCH] button. ⁄ • Only the channel number is stored. Category information is not stored. Preset Tuning Recalling the channels in the memory. 1 Enter Preset Tuning Select mode Press the [SEARCH] button. 2 Select a desired station in the memory Turn the [AUD] knob or push it towards up or down. 3 Recall the station Press the [AUD] knob. Cancelling Preset Tuning Press the [SEARCH] button. Channel Scan Every receivable Channel is checked for 10 seconds. 1 Start Channel Scan Select "CH-SCAN". For how to select Function Control items, refer to (page 6). 2 Release it when the channel you want to listen to is received Press the [AUD] knob. Function of remote control Direct Access Tuning Entering the channel and tuning. 1 Enter Direct Access Tuning mode Press the [DIRECT] button on the remote control. 2 Enter the channel Press the number buttons. 3 Do Channel Search Press the [4] or [¢] button. Cancelling Direct Access Tuning Press the [DIRECT] button on the remote control. ⁄ • If you make no button operation for 10 seconds, the Direct Access Tuning mode is automatically canceled. • If you cannot receive any signal in the input Channel due to bad conditions on radio wave or other such problems, "ACQUIRING SIGNAL"/ "NO SIGNAL" appears. English | 33