Kenwood KVT-719DVD Installation Manual - Page 9
Removing Monitor/Player Unit - accessories
View all Kenwood KVT-719DVD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Removing Monitor/Player Unit Removing the Hard Rubber Frame (escutcheon) 1. Engage the catch pins on the removal tool 6 and remove the two locks on the lower level. Lower the frame and pull it forward as shown in the figure. Removal Tool (Accessory 6) Removing the Unit 1. Remove the hard rubber frame by referring to the removal procedure in the section . 2. Remove the Hex-head screw with integral washer (M4 × 8) on the back panel. 3. Insert the two removal tools 6 deeply into the slots on each side, as shown. Removal Tool (Accessory 6) Catch Lock ⁄ • The frame can be removed from the top side in the same manner. 2. When the lower level is removed, remove the upper two locations. 4. Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside. ⁄ • Be careful to avoid injury from the catch pins on the removal tool. 5. Pull the unit all the way out with your hands, being careful not to drop it. English | 9