Kenwood TK-3101K Instruction Manual
Kenwood TK-3101K Manual
 |
View all Kenwood TK-3101K manuals
Add to My Manuals
Save this manual to your list of manuals |
Kenwood TK-3101K manual content summary:
- Kenwood TK-3101K | Instruction Manual - Page 1
INSTRUCTION MANUAL 4 4 •_ • 4F/JXCCI7 ,,MMiggpm .".111.11=1,1 1• UHF FM TRANSCEIVER (TK-3101) FreeTalk XLTM KENWOOD CORPORATION 862-1075-00 (K) 09 08 07 06 05 04 03 02 01 00 - Kenwood TK-3101K | Instruction Manual - Page 2
THANK YOU! We are grateful for your purchase of this KENWOOD transceiver. We believe this easy-to-use transceiver will provide you with dependable and reliable communications. KENWOOD MEANS WIRELESS Founded more than 50 years ago, KENWOOD's Car and Home Audio products are in demand around the world. - Kenwood TK-3101K | Instruction Manual - Page 3
INTRODUCTION KENWOOD welcomes you to the General Mobile Radio Service (GMRS). Your KENWOOD 2-way Business Radio is called a "transceiver, meaning "transmitter and receiver. For your convenience, this transceiver is equipped with automatic squelch control which - Kenwood TK-3101K | Instruction Manual - Page 4
FCC Rules require that all operators using Personal Radio Service frequencies obtain a radio license before operating their equipment -0177 from your fax machine and request document number 000574 for the form and instructions. If you would like an example of a completed 574 form, also request - Kenwood TK-3101K | Instruction Manual - Page 5
battery pack in an explosive atmosphere (gases, dust, fumes, etc.). • Turn OFF your transceiver while taking on fuel, or while parked in gasoline service stations. • Do not modify this transceiver for any reason. • Do not expose the transceiver to long periods of direct sunlight, nor place it close - Kenwood TK-3101K | Instruction Manual - Page 6
. Changes ormodifications to this equipmentmay cause harmfulinterference unless the modifications are expressly approvedth the instruction manual. The user couldlose the authority to operate this equipment ifanunauthorizedchange ormodificationIsmade. INFORMATION TO THEDIGITAL DEVICEUSERREQUIREDBY - Kenwood TK-3101K | Instruction Manual - Page 7
CONTENTS 7 UNPACKING otHipKINOtouIPM .!? ! •" 4:W* 1?!:!.. I ccesiories:„,„ :;:.;;::i r,i! :i! t,4! , .. 4 . ....1. .` .. "PIT( .:..ii*M : :%,::i;::::. Removing the'NiCasaft . . .!!..f. . .. 4,04 . .„..: titit#Ihey/400:0 aiiiiittnyttieBett • It loog the .O. t „.,..4:.0.., •.t6 - Kenwood TK-3101K | Instruction Manual - Page 8
-X3 1 Speaker/ microphone locking bracket J21-4493-X4 1 Belt Clip J29-0624-X3 1 Screw set N99-0396-X5 1 Warranty card - 1 License card B59-1603-XX 1 Instruction manual B62-1075-XX MigaMOWAr tategratMMOMMegregMMA S 1 - Kenwood TK-3101K | Instruction Manual - Page 9
Antenna Battery charger AC adaptor NiCd Battery Speaker/ microphone Speaker/ microphone pack (KNB-14) jack cover locking bracket O Belt clip Screw set g 2 g6g#afgm - Kenwood TK-3101K | Instruction Manual - Page 10
TERMINALS OR DISPOSE OF THEBATTERYBYFIRE • NEVERA7TEMPTTOREMOVE THE CASING FROM THE BATTERYPACK 1 Match the four grooves of the battery pack with the corresponding guides on the back of the transceiver. 2 Slide the battery pack along the back of the transceiver until the release latch on the base - Kenwood TK-3101K | Instruction Manual - Page 11
• Installing the Antenna Screw the antenna into the connector on the top of the transceiver by holding the antenna at its base and turning it clockwise until secure. Note: The antenna is neither a handle, a key ringretainer, nora speaker/microphone attachment point. Using the antenna in these ways - Kenwood TK-3101K | Instruction Manual - Page 12
• Installing the Cover over the Speaker/ Microphone Jacks If you are not using a speaker/ microphone, install the cover over the speaker/ microphone jacks using the supplied 3 x 6 mm screw. Speaker/ microphone jack cover Note; To keep the transceiver water resistant, youmust cover the speaker/ - Kenwood TK-3101K | Instruction Manual - Page 13
GETTING ACQUAINTED Antenna Microphone Speaker Speaker/ microphone jacks PTT (Push-To-Talk) switch Press this switch, then speak into the microphone to call a station. Release the switch to receive. C) Monitor key Press and hold this key to turn the squelch OFF. You will hear background noise. - Kenwood TK-3101K | Instruction Manual - Page 14
OPERATING BASICS ALVORMIWARRIVIRSig o•routre III r 1 Switch ON the transceiver by turning the Power switch/ Volume control clockwise. (3O-77-t • A beep sounds. 2 Adjust the volume by pressing and holding the Monitor key, then rotating the Power switch/ Volume control. 3 Rotate the Channel - Kenwood TK-3101K | Instruction Manual - Page 15
QUIET TALK (QT) QT allows you to hear only signals on your channel which are coded to match your transceiver. When a received signal has a code different from the one set up in your transceiver, squelch will not open and you will not hear the signal. When a received signal has a code that matches - Kenwood TK-3101K | Instruction Manual - Page 16
• QT Tone Setup Note: • Refer to the signalling codes listedin the table onpage 8. • When selecting a single digit number (0 - 9), always use 2 digits (00 - 09). • Whenyouare confirming the selectedsignalling number, there is a shortpause between the 10's digit andthe 1s digit. The transceiver - Kenwood TK-3101K | Instruction Manual - Page 17
4 Press the PIT switch to select the 10's digit of the signalling number. • Each time you press the PTT switch, a beep sounds and the 10's digit of the signalling number changes. There are a total of 4 different numbers (0 - 3). Press and hold PTT for 2 seconds Press PTT 1 time Press PTT 2 times - Kenwood TK-3101K | Instruction Manual - Page 18
Press and hold PTV' for 2 seconds Press PTT 1 time Press P11' 2 times Press PTT 3 times Press PTT 4 times Press PTT 5 times Press PTT 6 times Press PTT 7 times Press PTT 8 times Press PTT 9 times .a • . • Lte........7,i**15(100.::flatFU.Tir.i i: „ ,,,,,,,, x 1 second tone x1 • x2 x3 x - Kenwood TK-3101K | Instruction Manual - Page 19
9 Press the Monitor key again to confirm the beep pattern of the selected signalling number. 10 Repeat steps 3 to 9 to set up another channel. Example of setting up a channel with OT tone no. 01: 1 After entering OT tone setup mode, select channel 1. 2 Press and hold the PTT switch until a 1 - Kenwood TK-3101K | Instruction Manual - Page 20
CHANNEL SETTING CONFIRMATION i You can confirm the signalling code settings that are programmed in your transceiver. Note: • After confirming a setting, you must turn the power OFF and then ON again so the transceiver can operate normally • There is a shortpause between the confirmation of the 10 - Kenwood TK-3101K | Instruction Manual - Page 21
■ Reference Table r•• & 462.5625 2 462.5875 3 462.6125 4 462.6375 5 462.6625 6 462.6875 7 462.7125 8 462.5750 (White) 9 462.6250 (Black) 10 462.6750 (Orange)* 11 462.5500 12 462.6000 13 462.6500 14 462.7000 15 462.7250 * Emergency Channel: Use the emergency channel only for the purpose of - Kenwood TK-3101K | Instruction Manual - Page 22
TRANSCEIVER FUNCTIONS ■ Time-out Timer (TOT) The purpose of the Time-out Timer is to prevent any single person from using a channel for an extended period of time. If you continuously transmit for 3 minutes, the transceiver will stop transmitting and a tone will sound. To stop the tone, release the - Kenwood TK-3101K | Instruction Manual - Page 23
........ CHARGING THE NiCd BATTERY PACK '4. Initially charging the battery pack after purchase or extended storage (greater than 2 months) will not bring the battery pack to its normal operating capacity. After repeating the charge/discharge cycle two or three times, the operating capacity will - Kenwood TK-3101K | Instruction Manual - Page 24
1 Plug the AC adaptor cable into the adaptor jack located on the rear of the charger- 2 Plug the AC adaptor into an AC outlet. 3 Slide the NiCd battery r pack or the transceiver equipped with a NiCd battery pack into the charging slot. • Make sure the metal contacts on the battery pack come - Kenwood TK-3101K | Instruction Manual - Page 25
OPTIONAL ACCESSORIES You can use the following accessories with your transceiver: • KNB-14: Standard Battery (7.2 V/ 600 mAh) • KNB-15A: Long Life Battery (7.2 V/ 1100 mAh) • KSC-15: Regular Battery Charger • KSC-16: Rapid Battery Charger • KSC-21R: Refreshable Rapid Battery Charger • KHS-1: - Kenwood TK-3101K | Instruction Manual - Page 26
TROUBLESHOOTING GUIDE .0.41 Onfaiik No power. • The battery pack may be dead. Recharge or replace the battery pack. • The battery pack may not be installed correctly. Remove
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
 |
 |
INSTRUCTION
MANUAL
•_
•
4F/JXCCI7
4
4
,,
MMiggpm
.
".111.11=1,1
1•
UHF
FM
TRANSCEIVER
(TK-3101)
FreeTalk
XLTM
KENWOOD
CORPORATION
862-1075-00
(K)
09
08
07
06 05
04
03
02
01
00