Home » Kenwood Manuals » Electronics Accessories » Kenwood TK-3402U » Manual Viewer

Kenwood TK-3402U User Manual

Kenwood TK-3402U Manual

Get Kenwood TK-3402U PDF manuals and user guides

View all Kenwood TK-3402U manuals

Add to My Manuals
Save this manual to your list of manuals

Kenwood TK-3402U manual content summary:

Kenwood TK-3402U | User Manual - Page 1
TK-2402 TK-2402V TK-3402 TK-3402U VHF FM TRANSCEIVER UHF FM TRANSCEIVER INSTRUCTION MANUAL ÉMETTEUR-RÉCEPTEUR FM VHF ÉMETTEUR-RÉCEPTEUR FM UHF MODE D'EMPLOI TRANSCEPTOR FM VHF TRANSCEPTOR FM UHF MANUAL DE INSTRUCCIONES © B62-2479-00 (K, P) 09 08 07 06 05 04 03 02 01 00
Kenwood TK-3402U | User Manual - Page 2
ENGLISH VHF FM TRANSCEIVER UHF FM TRANSCEIVER TK-2402 TK-2402V TK-3402 TK-3402U INSTRUCTION MANUAL
Kenwood TK-3402U | User Manual - Page 3
you have chosen KENWOOD for your land mobile radio applications. NOTICES TO THE USER ◆ Government law prohibits the operation of unlicensed radio transmitters within the territories under government control. ◆ Illegal operation is punishable by fine and/or imprisonment. ◆ Refer service to qualified
Kenwood TK-3402U | User Manual - Page 4
harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this ATTENTION: The RBRC Recycle seal found on KENWOOD lithiumion (Li-ion) battery packs indicates KENWOOD's voluntary participation in an industry program to
Kenwood TK-3402U | User Manual - Page 5
the transceiver and the battery pack. • Do not use options not specified by KENWOOD. • If the die-cast chassis or other transceiver part is damaged, do not switch the transceiver power off before installing optional accessories. • The charger is the device that disconnects the unit from the AC mains
Kenwood TK-3402U | User Manual - Page 6
at gasoline service stations. • Near explosives or blasting sites. • In aircrafts. (Any use of the transceiver must follow the instructions and regulations immediately, remove the battery pack from the transceiver, and contact your KENWOOD dealer. • Use of the transceiver while you are driving may
Kenwood TK-3402U | User Manual - Page 7
Information concerning the battery pack: The battery pack includes flammable objects such as organic solvent. Mishandling may cause the battery to rupture producing flames or extreme heat, deteriorate, or cause other forms of damage to the battery. Please observe the following prohibitive matters. •
Kenwood TK-3402U | User Manual - Page 8
charged in unspecified conditions (under high temperature over the regulated value, excessive high voltage or current over regulated value, or with a remodeled charger), it may overcharge or an abnormal chemical reaction may occur. The battery may generate heat or smoke, rupture, or burst into flame
Kenwood TK-3402U | User Manual - Page 9
eyes. Go to the hospital immediately. If left untreated, it may cause eye-problems. • Do not charge the battery for longer than the specified time! If the or seems abnormal for any other reason, remove it from the charger or operating equipment and do not use it. The battery may generate heat or smoke,
Kenwood TK-3402U | User Manual - Page 10
• Antenna 1 • Battery charger/ AC adapter 1 K type: KSC-35S P type: KSC-43 • Li-ion Battery pack (KNB-45L 1 • Speaker/ microphone jack cover 1 • Speaker/ microphone locking bracket 1 • Belt clip (KBH-10 1 • Screw (M3 x 8 mm 2 • Channel stopper 1 • Instruction manual 1 Note: Refer to
Kenwood TK-3402U | User Manual - Page 11
PREPARATION INSTALLING THE CHANNEL STOPPER For transceivers with less than 16 channels, insert a Channel stopper. 1 Set the Channel selector to channel 1, then pull the Channel selector knob off the transceiver. • If the Channel selector is not positioned at channel 1, the Channel selector knob may
Kenwood TK-3402U | User Manual - Page 12
INSTALLING/ REMOVING THE BATTERY PACK ◆ Do not short the battery terminals or dispose of the battery by fire. ◆ Never attempt to remove the casing from the battery pack. 1 Align the battery pack with the back of the transceiver, then press the battery pack and transceiver firmly together until the
Kenwood TK-3402U | User Manual - Page 13
the locking tabs to secure it in place. Holder Li-ion battery charger Ni-MH battery charger • To remove the Holder, squeeze the locking tabs together then pull the Holder out of the charger. 4 Slide a battery pack or a transceiver equipped with a battery pack into the
Kenwood TK-3402U | User Manual - Page 14
: ◆ When the indicator blinks red, the battery pack is either defective or the battery pack contacts are not properly mated with those of the charger. ◆ When the indicator flashes green and orange, the battery pack has not satisfied the charging start temperature. Remove the battery pack from the
Kenwood TK-3402U | User Manual - Page 15
INSTALLING THE OPTIONAL SPEAKER/ MICROPHONE (OR HEADSET) Note: The transceiver is not fully water resistant when using a speaker/ microphone or headset. 1 Insert the speaker/ microphone (or headset) plugs into the speaker/ microphone jacks of the transceiver. 2 Place the locking bracket over the
Kenwood TK-3402U | User Manual - Page 16
ORIENTATION Microphone Antenna Speaker Battery pack Channel selector Rotate to change the operating channel. • Channel Annunciation: When changing channels, the transceiver will announce the newly selected channel number (if enabled by your dealer). LED indicator For the LED indicator status,
Kenwood TK-3402U | User Manual - Page 17
PROGRAMMABLE AUXILIARY FUNCTIONS Your dealer can program the Side 1 and Side 2 keys each with one of the following functions. Note: The duration of pressing a key to activate a function is dependent on your dealer setting. Your dealer may have set some keys to be held down for a short duration
Kenwood TK-3402U | User Manual - Page 18
■ Key Lock with Status Memory This operates the same as Key Lock except that when the transceiver power is turned OFF and then ON again, the keys remains locked. ■ Lone Worker Lone Worker Mode is a safety feature built into the transceiver. If the transceiver is not operated for a preprogrammed
Kenwood TK-3402U | User Manual - Page 19
■ Scan Press this key to start scanning the transceiver channels. ■ Scan + Temporary Delete Scan pauses at an undesired channel, you can remove that channel from the scanning sequence by press or hold this key. ■ Scrambler The Scrambler function allows you to hold a conversation in complete privacy.
Kenwood TK-3402U | User Manual - Page 20
BASIC OPERATIONS 1 Turn the Power switch/ Volume control clockwise to switch the transceiver power ON. • A beep sounds if enabled by your dealer. 2 Press the key programmed with the [Monitor] or [Squelch Off] function to hear background noise, then rotate the Power switch/ Volume control to adjust
Kenwood TK-3402U | User Manual - Page 21
operation allows you to transmit hands-free. This feature must first be activated by your dealer, and can only be used if you are using a supported headset. This function can be turned off for specific channels by your dealer. To activate VOX and set the VOX Gain level, perform the following
Kenwood TK-3402U | User Manual - Page 22
BACKGROUND OPERATIONS TIME-OUT TIMER (TOT) The Time-out Timer prevents callers from using a channel for an extended duration. If you continuously transmit for the duration programmed by your dealer (default is 1 minute), transmission will stop and an alert tone will sound. To stop the tone, release
Kenwood TK-3402U | User Manual - Page 23
. The DTMF decode capabilities include Selective Call ID, Transpond with ID, and "Wild Card" Group Calling. ■ FleetSync Utilizing JVC KENWOOD's FleetSync digital signaling protocol, this transceiver has PTT ID and Selective Calling capabilities for managed dispatch operations. For hazardous/hostile
Kenwood TK-3402U | User Manual - Page 24
ADDENDUM: Transceiver Password If your transceiver is password protected, the LED will light blue when you turn the transceiver ON. Enter the password (up to 4 digits) using the following procedure. 1 Set the Channel selector to position "1". 2 Press the Side 1 or Side 2 key to enter the first digit