Kenwood TK-3407 Operation Manual

Kenwood TK-3407 Manual

Get Kenwood TK-3407 PDF manuals and user guides View all Kenwood TK-3407 manuals
Add to My Manuals
Save this manual to your list of manuals

Kenwood TK-3407 manual content summary:

  • Kenwood TK-3407 | Operation Manual - Page 1
    INSTRUCTION MANUAL VHF FM TRANSCEIVER TK-2407 UHF FM TRANSCEIVER TK-3407 © B62-2480-10 (M)
  • Kenwood TK-3407 | Operation Manual - Page 2
    of unlicensed radio transmitters within the territories under government control. ◆ Illegal operation is punishable by fine and/or imprisonment. ◆ Refer service to qualified technicians only. Safety: It is important that the operator is aware of, and understands, hazards common to the operation
  • Kenwood TK-3407 | Operation Manual - Page 3
    powders, grain powders, etc.). • While taking on fuel or while parked at gasoline service stations. • Near explosives or blasting sites. • In aircrafts. (Any use of the transceiver must follow the instructions and regulations provided by the airline crew.) • Where restrictions or warnings are posted
  • Kenwood TK-3407 | Operation Manual - Page 4
    Information concerning the battery pack: The battery pack includes flammable objects such as organic solvent. Mishandling may cause the battery to rupture producing flames or extreme heat, deteriorate, or cause other forms of damage to the battery. Please observe the following prohibitive matters. •
  • Kenwood TK-3407 | Operation Manual - Page 5
    • Use only the specified charger and observe charging requirements! If the battery is charged in unspecified conditions (under high temperature over the regulated value, excessive high voltage or current over regulated value, or with a remodeled charger), it may overcharge or an abnormal chemical
  • Kenwood TK-3407 | Operation Manual - Page 6
    your eyes with fresh water as soon as possible, without rubbing your eyes. Go to the hospital immediately. If left untreated, it may cause eye-problems. • Do not charge the battery for longer than the specified time! If the battery pack has not finished charging even after the regulated time has
  • Kenwood TK-3407 | Operation Manual - Page 7
    , file a claim with the carrier immediately. Supplied Accessories • Speaker/ microphone jack cover 1 • Speaker/ microphone locking bracket 1 • Belt clip (KBH-10 1 • Screw (M3 x 8 mm 1 • Channnel stopper 1 • Instruction manual 1 Note: Refer to "PREPARATION" for accessory installation
  • Kenwood TK-3407 | Operation Manual - Page 8
    PREPARATION INSTALLING THE CHANNEL STOPPER For transceivers with less than 16 channels, insert a Channel stopper. 1 Set the Channel selector to channel 1, then pull the Channel selector knob off the transceiver. • If the Channel selector is not positioned at channel 1, the Channel selector knob may
  • Kenwood TK-3407 | Operation Manual - Page 9
    Installing/ Removing the (OPTIONAL) Battery Pack ◆ Do not short the battery terminals or dispose of the battery by fire. ◆ Never attempt to remove the casing from the battery pack. 1 Align the battery pack with the back of the transceiver, then press the battery pack and transceiver firmly together
  • Kenwood TK-3407 | Operation Manual - Page 10
    Charging the Battery Pack (OPTIONAL BATTERY CHARGER) The battery pack is not charged at the factory; charge it before use. ATTENTION: Always switch OFF a transceiver equipped with a battery pack before inserting the transceiver into the charger. 1 Plug the AC adapter cable into the jack located on
  • Kenwood TK-3407 | Operation Manual - Page 11
    5 When charging is completed, the indicator lights green. Remove the battery pack or the transceiver from the charging slot of the charger. • It takes approximately 3 hours to charge the battery pack. • When the charger will not be used for a long time, unplug the AC adapter from the AC outlet. Note
  • Kenwood TK-3407 | Operation Manual - Page 12
    INSTALLING THE OPTIONAL SPEAKER/ MICROPHONE (OR HEADSET) Note: The transceiver is not fully water resistant when using a speaker/ microphone or headset. 1 Insert the speaker/ microphone (or headset ) plugs into the speaker/ microphone jacks of the transceiver. 2 Place the locking bracket over the
  • Kenwood TK-3407 | Operation Manual - Page 13
    ORIENTATION Microphone Antenna Speaker Battery pack Channel selector Rotate to change the operating channel. • Channel Annunciation: When changing channels, the transceiver will announce the newly selected channel number (if enabled by your dealer). LED indicator For the LED indicator status,
  • Kenwood TK-3407 | Operation Manual - Page 14
    PROGRAMMABLE AUXILIARY FUNCTIONS Your dealer can program the Side 1 and Side 2 keys each with one of the following functions. Note: The duration of pressing a key to activate a function is dependent on your dealer setting. Your dealer may have set some keys to be held down for a short duration
  • Kenwood TK-3407 | Operation Manual - Page 15
    ■ Key Lock with Status Memory This operates the same as Key Lock except that when the transceiver power is turned OFF and then ON again, the keys remains locked. ■ Lone Worker Lone Worker Mode is a safety feature built into the transceiver. If the transceiver is not operated for a preprogrammed
  • Kenwood TK-3407 | Operation Manual - Page 16
    ■ Scan + Temporary Delete Scan pauses at an undesired channel, you can remove that channel from the scanning sequence by press or hold this key. ■ Scrambler The Scrambler function allows you to hold a conversation in complete privacy. When activated, any other party listening in on your channel will
  • Kenwood TK-3407 | Operation Manual - Page 17
    BASIC OPERATIONS 1 Turn the Power switch/ Volume control clockwise to switch the transceiver power ON. • A beep sounds if enabled by your dealer. 2 Press the key programmed with the [Monitor] or [Squelch Off] function to hear background noise, then rotate the Power switch/ Volume control to adjust
  • Kenwood TK-3407 | Operation Manual - Page 18
    operation allows you to transmit hands-free. This feature must first be activated by your dealer, and can only be used if you are using a supported headset. This function can be turned off for specific channels by your dealer. To activate VOX and set the VOX Gain level, perform the following
  • Kenwood TK-3407 | Operation Manual - Page 19
    BACKGROUND OPERATIONS Time-Out Timer (TOT) The Time-out Timer prevents callers from using a channel for an extended duration. If you continuously transmit for the duration programmed by your dealer (default is 1 minute), transmission will stop and an alert tone will sound. To stop the tone, release
  • Kenwood TK-3407 | Operation Manual - Page 20
    Signaling ■ QT/ DQT The Encoder/Decoder function uses QT/ DQT to segregate talk groups, so users only hear calls from their own group. ■ DTMF A DTMF PTT ID is included for dispatch operations or simple remote control applications. The DTMF decode capabilities include Selective Call ID, Transpond
  • Kenwood TK-3407 | Operation Manual - Page 21
    VHF TK-2407 UHF TK-3407
  • Kenwood TK-3407 | Operation Manual - Page 22
    致謝 KENWOOD τΌ‫׌‬j JVC KENWOOD Corporation保留KENWOOD 注意事項 KENWOOD
  • Kenwood TK-3407 | Operation Manual - Page 23
    警告 注意 KENWOOD i
  • Kenwood TK-3407 | Operation Manual - Page 24
    j 危險 l l l e 80˚C l l d l ii
  • Kenwood TK-3407 | Operation Manual - Page 25
    危險 l d d l l l l l l l iii
  • Kenwood TK-3407 | Operation Manual - Page 26
    警告 l l l l iv
  • Kenwood TK-3407 | Operation Manual - Page 27
    ͦ፽ 1 2 7 8 11 VOX 12 13 1 1 KBH-10 1 • 螺絲(M3 x 8 mm 2 1 1 ‫ء‬j 1
  • Kenwood TK-3407 | Operation Manual - Page 28
    ๟௪ʈЪ 16 1 1 1 2 3 • 2，4，6，8，10，12和14 4 天線 為止。 ‫ء‬j 2
  • Kenwood TK-3407 | Operation Manual - Page 29
    1 2 3 τༀͤ੭Ѱ 皮帶夾 M3 x 8 mm ‫ء‬j 注意 3
  • Kenwood TK-3407 | Operation Manual - Page 30
    ‫ء‬จj 1 2 3 KSC-43> 電池座 KSC-43> 4 指示燈 指示燈 5 3 線。 4
  • Kenwood TK-3407 | Operation Manual - Page 31
    ‫ء‬j 5˚C 與 40˚C ‫ء‬j 1 2 2mm 5
  • Kenwood TK-3407 | Operation Manual - Page 32
    ‫ء‬j 1 2 3 6
  • Kenwood TK-3407 | Operation Manual - Page 33
    ֛Σ 天線 麥克風 揚聲器 電池組 j LED ܸͪዱ 有關 LED 11 PTT 1 8 2 8 7
  • Kenwood TK-3407 | Operation Manual - Page 34
    1 和ਉ၌ 2 ‫ء‬j ■ 2 2 DTMF PTT 8
  • Kenwood TK-3407 | Operation Manual - Page 35
    QT/DQT、FleetSync QT/DQT、FleetSync ID ID 發送 FleetSync 9
  • Kenwood TK-3407 | Operation Manual - Page 36
    ■ ೯৔ GPS GPS ■ ً࿒ 1/ً࿒ 2 10
  • Kenwood TK-3407 | Operation Manual - Page 37
    ਿ͉዁Ъ 1 2 3 4 PTT 3 至 4 5 放開 PTT ‫ء‬j LED ў່ 發射 接收呼叫 QT/DQT、FleetSync 信號等) FleetSync、DTMF 或 2 LED 11
  • Kenwood TK-3407 | Operation Manual - Page 38
    VOX) VOX 1 2 1 3 1 LED 1 VOX 4 1 VOX 2 VOX 5 按下 PTT VOX 6 VOX。 ‫ء‬j 20 VOX 1 VOX 10 VOX 12
  • Kenwood TK-3407 | Operation Manual - Page 39
    TOT) 1 PTT ཥϫ޲ཥ 5 ‫ء‬j QT/DQT QT/DQT LED 30 LED BCL) BCL PTT PTT ‫ء‬j在使用 QT、DQT、DTMF 或 FleetSync BCL 13
  • Kenwood TK-3407 | Operation Manual - Page 40
    ‫ڦ‬໮ ■ QT/ DQT QT/ DQT ■ DTMF 隨帶的 DTMF PTT ID DTMF ID、帶 ID Wild Card ■ FleetSync JVC KENWOOD 的 FleetSync PTT ID 1 或ਉ၌ 2 ■ MDC-1200 MDC 信號：PTT ID PTT ID PTT ID 信號。 14
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
INSTRUCTION MANUAL
© B62-2480-10 (M)
VHF FM TRANSCEIVER
TK-2407
UHF FM TRANSCEIVER
TK-3407