Kenwood TKR-D710 Instruction Manual 1

Kenwood TKR-D710 Manual

Get Kenwood TKR-D710 PDF manuals and user guides View all Kenwood TKR-D710 manuals
Add to My Manuals
Save this manual to your list of manuals

Kenwood TKR-D710 manual content summary:

  • Kenwood TKR-D710 | Instruction Manual 1 - Page 1
    dealer. You may be exposing person or persons to excess radio frequency radiation. You may contact your radio dealer or the manufacturer for further instructions. Maintain a separation distance from the antenna to person(s) of at least 120 cm (4 feet) , 50% duty Cycle. You, as the qualified end-user
  • Kenwood TKR-D710 | Instruction Manual 1 - Page 2
    pour plus d'informations. AVERTISSEMENT Maintenez une distance de séparation entre l'antenne et la/les personne(s) d'au moins 120 cm (4 pieds), cycle de service de 50%. Vous devez, en votre qualité d'utilisateur final qualifié de cet appareil radio, contrôler les conditions d'exposition des passants
  • 1
  • 2
MANDATORY SAFETY INSTRUCTIONS TO INSTALLERS AND USERS
•
Use only manufacturer or dealer supplied antenna.
•
Antenna Minimum Safe Distance:
120 cm (4 feet), 50% duty Cycle.
•
Antenna Gain:
0
dBd referenced to a dipole.
The Federal Communications Commission has adopted a safety standard for
human exposure to RF (Radio Frequency) energy which is below the OSHA
(Occupational Safety and Health Act) limits.
•
Antenna Mounting:
The antenna supplied by the manufacturer or
radio dealer must not be mounted at a location such that during radio
transmission, any person or persons can come closer than the above
indicated minimum safe distance to the antenna, i.e.
120 cm (4 feet) ,
50% duty Cycle.
•
To comply with current FCC RF Exposure limits, the antenna must be
installed at or exceeding the minimum safe distance shown above, and in
accordance with the requirements of the antenna manufacturer or supplier.
•
Vehicle installation:
The antenna can be mounted at the center of a vehicle
metal roof or trunk lid, if the minimum safe distance is observed.
•
Base Station Installation:
The antenna should be fixed-mounted on
an outdoor permanent structure.
RF Exposure compliance must be
addressed at the time of installation.
Antenna substitution:
Do not substitute any antenna for the one supplied or
recommended by the manufacturer or radio dealer.
You may be exposing person or persons to excess radio frequency radiation.
You may contact your radio dealer or the manufacturer for further instructions.
Maintain a separation distance from the antenna to person(s) of at least
120 cm (4 feet)
,
50% duty Cycle.
You, as the qualified end-user of this radio device must control the exposure
conditions of bystanders to ensure the minimum separation distance (above)
is maintained between the antenna and nearby persons for satisfying RF
Exposure compliance.
The operation of this transmitter must satisfy the
requirements of Occupational/Controlled Exposure Environment, for work-
related use, transmit only when person(s) are at least the minimum distance
from the properly installed, externally mounted antenna.
Transmit only when
people outside the vehicle are at least the recommended minimum lateral
distance away from the antenna/vehicle.
B59-2353-10
© 2015