KitchenAid KUDS40FVSS User Manual - Page 5

OPTION SELECTIONS OPTIONS DISH LOAD TYPES DESCRIPTIONS USE WITH: Pans, casseroles, etc. with tough food soil. Activates the PROSCRUB® spray jets and provides intensified water spray to the back of the lower level rack. May add heat and time to the cycle. Heavy Duty or Normal cycle To sanitize your dishes and glassware in accordance with NSF/ANSI Standard 184 for Residential Dishwashers. Raises the water temperature in the final rinse to approximately 155°F (68°C). This high temperature rinse sanitizes your dishes and glassware in accordance with NSF/ANSI Standard 184 for Residential Dishwashers. Certified residential dishwashers are not intended for licensed food establishments. The Sanitize or Sani Rinse option adds heat and time to the cycle. Normal cycle. Heavy Duty cycle automatically uses Sani Rinse. Only these sanitization cycles have been designed to meet the NSF/ANSI requirements. Loads containing tough, baked-on food. Increases the target water temperature during the wash portions of the cycle. Adds heat, wash time and water to the cycle. Heavy Duty or Normal cycles For best drying results, dry dishes with heat. Turn OFF when loads contain plastic dinnerware that may be sensitive to high temperatures. This option with the use of rinse aid will provide the best drying performance. All cycles, except Rinse Only. Automatic with all wash cycles unless you turn it off. To run your dishwasher at a later time or during offpeak hours. Delays the start of a cycle up to 4 hours. Select a wash cycle and options. Press 4 Hour Delay. Press START/RESUME. Close the door firmly. All cycles, except Rinse Only Control Lock To avoid unintended use of your dishwasher, or cycle and option changes during a cycle. To turn on Lock, press and hold Heat Dry for at least 4 seconds. To turn off Lock, press and hold Heat Dry for at least 4 seconds. When Control Lock is lit, all buttons are disabled. If you press any pad while your dishwasher is locked, the light flashes 3 times. The dishwasher door can be opened while the controls are locked. Anytime IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle will automatically compensate by adding time, heat and water as needed. CONTROLS AND CYCLE STATUS CONTROL PURPOSE To start or resume a wash cycle To cancel wash cycle COMMENTS If the door is opened during a cycle or the power is interrupted, the START/RESUME indicator flashes. The cycle will not resume until the door is closed and START/RESUME is pressed. Note: If the START/RESUME button is located on top of door, push door firmly closed within 3 seconds of pressing START/RESUME. Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher drain completely. To follow the progress of your dishwasher cycle Clean indicator glows when a cycle is finished. If you select the Sani Rinse option, when the Sani Rinse cycle is finished, the Sanitized indicator glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the cycle. This can happen if the cycle is interrupted, or the water could not be heated to the required temperature. The light goes off when you open and close the door or press CANCEL. 5