Kodak ESP 3 User guide - Page 11

USB Port Product Overview You can use the USB port on the front panel of the Kodak ESP 3 All-in-One printer to connect a PictBridge camera and print pictures directly from the camera. The Kodak ESP 3 All-in-One printer can access images from most digital cameras. You can also use the USB port to access pictures on a USB device, such as a thumb drive, and transfer them to your computer. Status Lights The following tables provide information on the Kodak ESP 3 All-in-One printer status lights. Light Status All lights and displays are off. All lights flash once. Control Panel Cause The printer is turned off. The printer does not have power applied. The printer is initializing. All lights are flashing The printer has detected an error and the On/Off light is condition. flashing amber. Action/Solution Press On/Off to turn the printer on. Ensure that the power cord is properly plugged into the back of the printer. None. Allow the printer to finish the initialization process. Disconnect power for 5 seconds and reconnect power. If the condition persists, contact Kodak for assistance. Light Status Check Color Ink light is off. Check Color Ink light blinks every few seconds. Check Color Ink light is flashing. Check Color Ink light is flashing rapidly. Check Color Ink Light Cause Action/Solution Normal operation. This light should None. be off when a color ink cartridge has been properly installed and has enough ink to print. The color ink cartridge ink level is Check the ink level in the Home Center low. or on the printer status monitor (Windows). The color ink cartridge needs to be Replace the color ink cartridge. replaced. The color ink cartridge needs attention. Ensure that the color ink cartridge is installed properly.