Konica Minolta MS7000 MK II UC-7 Operator Manual
Konica Minolta MS7000 MK II Manual
 |
View all Konica Minolta MS7000 MK II manuals
Add to My Manuals
Save this manual to your list of manuals |
Konica Minolta MS7000 MK II manual content summary:
- Konica Minolta MS7000 MK II | UC-7 Operator Manual - Page 1
Universal Carrier UC7 Operator's Manual Minolta Corporation, 101 Williams Drive, Ramsey, NJ 07446-1293, USA - Konica Minolta MS7000 MK II | UC-7 Operator Manual - Page 2
Introduction This instruction manual explains the operation of the Minolta Universal Carrier UC7. Read it carefully before using the equipment to ensure proper usage. The UC7 is designed for use with Minolta reader-printers and scanners. Specifications Product name: Microforms: Film Loading: Film - Konica Minolta MS7000 MK II | UC-7 Operator Manual - Page 3
spindle Slow Fast rewind Take up spindle Fast forward 16 - 35mm adjustable guide rollers Scan Installation When preparing the reader-printer for use with the UC7, use the operator's manual for the specific reader-printer or scanner you are working on. Remove any carrier and lens according to - Konica Minolta MS7000 MK II | UC-7 Operator Manual - Page 4
. 1 Important: Direction of receiver plate • Position receiver plate according to Fig.1. Slide carrier on to the receiver plate from the right side of the reader-printer. Make sure the carrier is pulled to its outermost end stop as Fig. 2 shows and the motor mount is on the left of lens holder - Konica Minolta MS7000 MK II | UC-7 Operator Manual - Page 5
Plug to interface PWB Film 16mm setup 35mm setup • Set up guide rollers for either, 16 or 35mm. • Place full spool of film until cover glass is fully open. • Feed film under left guide roller, cover glass and right guide roller to the right take up reel. • Slide film into the take up reel Fig. - Konica Minolta MS7000 MK II | UC-7 Operator Manual - Page 6
Fig.4 For fine adjustment use the center buttons ( < or > ) For scanning use the 2 outer gray buttons ( > ) Important: For fast forward and fast rewind ( > ) the carrier has to be pulled all the way forward so the cover glass is open all the way. 6 - Konica Minolta MS7000 MK II | UC-7 Operator Manual - Page 7
Operating Fiche Take hold of the handle of the carrier and pull forward as far as it will go. This will cause the upper glass to swing open. Slide Fiche onto the lower glass. COM Fiche: Place Fiche face down with its cut out positioned on the right front. SOURCE Document Fiche: Place the Fiche - Konica Minolta MS7000 MK II | UC-7 Operator Manual - Page 8
Maintenance The upper and the lower glass flats must be cleaned regularly for optimum performance. Remove lens from the reader-printer and set aside. Now the cover glass may be easily removed by lifting it out of the frame. It helps to pull the carrier halfway
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
Universal Carrier UC7
Operator’s Manual
Minolta Corporation, 101 Williams Drive, Ramsey, NJ 07446-1293, USA