Konica Minolta Fujitsu fi-6800 Operating Guide - Page 131

Chapter 7 Replacing Consumables 7.1 Consumables and Replacement Cycles The following table shows the consumables used for the scanner. Name Part No. Suggested replacement cycle PICK ROLLER PA03575-K011 600,000 sheets or one year SEPARATOR ROLLER PA03575K012 600,000 sheets or one year Consumables must be replaced periodically. It is recommended that you keep a stock of new consumables and replace them before it reaches the end of the consumable life. The scanner records the number of sheets scanned after replacing the consumables (for pick roller, separator roller, brake roller), which allows you to check the status on each consumable. To check the status on the usage of the consumables, refer to "9.3 Settings Related to Page Counters" (page 182). Note that the suggested replacement cycles are guidelines for using A4 (80 g/m2 [20 lb]) wood-free or wood containing papers, as these cycles vary depending on the type of papers scanned and how often the scanner is used and cleaned. Only use the specified consumables. BRAKE ROLLER PA03575K013 600,000 sheets or one year To purchase the consumables, contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider. Please note that some parts (other than the consumables) need to be replaced by a service engineer, depending on the type of documents scanned and how often the scanner is used. For instance, Maintenance Parts (e.g. assist roller) need to be replaced by a service engineer. For more information, contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider. TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing Consumables Troubleshooting Operational Settings Appendix Glossary 131