Konica Minolta Fujitsu fi-6800 Operating Guide - Page 194
Specifying the Number of Feeding Retries [Number of paper feeding retries], Specifying the Interval
View all Konica Minolta Fujitsu fi-6800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 194 highlights
Chapter 9 Operational Settings Specifying the Number of Feeding Retries [Number of paper feeding retries] Configure this setting to change the number of feeding retries upon pick errors. 1 Start up the Software Operation Panel. Refer to "9.1 Starting Up the Software Operation Panel" (page 170). 2 From the listing on the left, select [Device Setting 2] J [Number of paper feeding retries]. Specifying the Interval to Feed the Documents [Set the interval for feeding sheets] If the scanned image is partially missing at the bottom due to a large skew when scanning in Automatic Page Size Detection, specify a longer interval to feed the documents to leave more time between each document to be scanned. 1 Start up the Software Operation Panel. Refer to "9.1 Starting Up the Software Operation Panel" (page 170). 2 From the listing on the left, select [Device Setting 2] J [Set the interval for feeding sheets]. TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing Consumables 3 Specify the number of paper feeding retries. You can select from1 to 12 times. This setting can also be configured from the operator panel. 3 Specify the paper feeding interval. You can select from [Short (Default)] to [Long] (in four levels). Note that it takes more time for scanning as the paper feeding interval becomes longer. Troubleshooting Operational Settings Appendix Glossary 194