Konica Minolta Fujitsu fi-6800 Operating Guide - Page 215
Setting the Waiting Time to Enter Power Saving Mode [Power saving
View all Konica Minolta Fujitsu fi-6800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 215 highlights
Chapter 9 Operational Settings Setting the Waiting Time to Enter Power Saving Mode [Power saving] When the scanner is not being used for a certain period of time, it enters power saving mode to save the power consumption. 1 Start up the Software Operation Panel. Refer to "9.1 Starting Up the Software Operation Panel" (page 170). 2 From the listing on the left, select [Device Setting]. 3 Use the slide bar to specify the waiting time to enter power saving mode. It can be set in the range of 5 to 235 minutes (in increments of 5 minutes). TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing Consumables Troubleshooting Operational Settings Appendix Glossary 215