Konica Minolta Fujitsu fi-6800 Operating Guide - Page 218
Imprinter Settings [Imprinter selection
View all Konica Minolta Fujitsu fi-6800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 218 highlights
Chapter 9 Operational Settings Imprinter Settings [Imprinter selection] Specify which imprinter to use when both Front-Side Imprinter and Back-Side Imprinter are installed. This setting does not appear when no imprinter is installed. 1 Start up the Software Operation Panel. Refer to "9.1 Starting Up the Software Operation Panel" (page 170). 2 From the listing on the left, click [Device Setting 2] J [Imprinter selection]. 3 Select the Imprinter to use. Normal Follows the scanner driver setting. (obey Host specification): Forcibly select Front-Side Imprinter: Forces the Front-Side Imprinter to be used unless specified otherwise by the scanner driver. Forcibly select Back-Side Imprinter: Forces the Back-Side Imprinter to be used unless specified otherwise by the scanner driver. z For information about the Imprinter, refer to "A.4 Scanner Options" (page 225). z This setting can also be configured from the scanner driver's setup dialog box. Note that priority is given to the scanner driver setting. TOP Contents Index Introduction Scanner Overview How to Load Documents Configuring the Scan Settings How to Use the Operator Panel Various Ways to Scan Daily Care Replacing Consumables Troubleshooting Operational Settings Appendix Glossary 218