Konica Minolta bizhub C35 bizhub C35 Printer/Copier/Scanner User Guide - Page 115
Mode 2], Quality Mode], Mode 2]: Low mode - instructions
View all Konica Minolta bizhub C35 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
[Fine Line ADJ] Settings -3 to 2 (Default: 0) Adjust how fine lines are reproduced by changing the applied voltage (VC) to the electrostatic roller. [AIDC Mode] Settings [Mode 1] / [Mode 2] Select the AIDC operation mode. [Mode 1]: Standard mode [Thick Mode] [Mode 2]: Low mode Settings [Quality Mode] / [Speed Mode] In order to prevent toner from clogging within the developer unit as a result of it being driven at half-speed, select the timing for driving the developer unit at full speed for a fixed length of time when thick paper is being fed. [Quality Mode]: While printing on thick paper, printing is periodically paused, and the developer unit is driven at full speed for a fixed length of time. Since printing is paused, the quality is not affected; however, a standby time of approximately 70 seconds occurs every 400 seconds or so of half-speed operation. [Engine DipSW] [Speed Mode]: While printing on thick paper, only the drive of the developer unit periodically switches to full speed for a fixed length of time. Since printing continues during full-speed drive, the print quality is slightly affected, however the standby time is short. Change the DIP switches to control machine operation. [Engine DipSW 1] [Engine DipSW 28] Settings [ON] / [OFF] Use to change engine settings. " Normally, there is no need to change the settings. If it becomes necessary to change the settings, do so according to the instructions from the service representative. 3-68 [Admin Settings]