Konica Minolta bizhub C652 bizhub C452/C552/C552DS/C652/C652DS Enlarge Display - Page 33

3.2 Configuring the basic settings 3 Settings Staple/Punch Staple: Copies can be bound with a staple in the corner or with two staples. Punch: Copies can be fed out hole-punched. The number of punched holes varies depending on the country (area) where this machine is used. For details, contact your service representative. Staple/Punch Fold/Bind 1 1 Position Setting Half-Fold Select the desired staple or hole-punch position. • [Auto]: The staple or hole-punch position is automatically set either at the top or at the left. A staple or punch position along the long side of the paper is selected if the original length is 11-11/16 in (297 mm) or less. A staple or punch position along the short side of the paper is selected if the original length exceeds 11-11/16 in (297 mm). • If [Auto] is selected for the staple or holepunch position, load the original with the top toward the back of the machine. • If desired, press [Original Direction], and then specify the direction in which the original is loaded. Select this setting to fold copies at the center in half before feeding them out. Center Staple & Fold Select this setting to staple copies at the center before feeding them out. Tri-Fold Select this setting to fold copies in three before feeding them out. bizhub C652/C652DS/C552/C552DS/C452 3-12